|
|
|||||||
| Gas Club Car Gas DS, and Precedent golf cars |
  |
|
|
Thread Tools | Display Modes |
07-10-2015, 07:28 AM
|
#1 |
|
Not Yet Wild
Join Date: Mar 2015
Location: NC
Posts: 6
|
Broke the micro switch studs!
I have a 94 CC DS that I've been working on for a bit. Had to rewire everything off of the ignition switch, due to some broken and some strained wires (got hung up on a branch - I wasn't driving), had to replace the starter/generator, and found earlier this week that the micro switches were shot. I got new switches in yesterday, and proceeded to replace them last night. The two tiny studs that hold the micro switches on the FNR assembly were rusted. I haven't found any seized fasteners on this cart, so I put a socket on a screwdriver, and proceeded to snap the studs right off at the back side of the nut. There was enough stud left to install the micro switches (taped in place for now), so I could test the cart, but I want to fix them correctly. Are those studs replaceable, or are they integrated into the back side of the FNR assembly? It wasn't clear as I looked at them, and I didn't want to break it any more trying to figure it out. Thanks!
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
07-10-2015, 08:14 AM
|
#2 |
|
Gone Wild
Join Date: Jan 2014
Location: Medina ohio
Posts: 914
|
Re: Broke the micro switch studs!
They replaceable they are just little bolts
|
|
|
|
|
07-10-2015, 09:52 AM
|
#3 |
|
Not Yet Wild
Join Date: Mar 2015
Location: NC
Posts: 6
|
Re: Broke the micro switch studs!
Sweet. I'll have to dig into it to see how they go in, and how they are going to come out. Are they actually bolts, if so, do they thread in from the front of the FNR bracket, or are they studs that thread in from the back (engine) side?
|
|
|
|
|
07-10-2015, 03:10 PM
|
#4 |
|
Gone Wild
Join Date: Jan 2014
Location: Medina ohio
Posts: 914
|
Re: Broke the micro switch studs!
Actual bolts
|
|
|
|
|
07-10-2015, 04:50 PM
|
#5 |
|
Gone Wild
Join Date: Oct 2009
Location: Lee County, Georgia
Posts: 521
|
Re: Broke the micro switch studs!
In a 1998 parts manual it is a SCREW, MACHINE, #4 - 40 x 1 1/2
|
|
|
|
|
07-10-2015, 06:04 PM
|
#6 |
|
Not Yet Wild
Join Date: Mar 2015
Location: NC
Posts: 6
|
Re: Broke the micro switch studs!
Cool. You guys are awesome! Thanks!
|
|
|
|
|
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| 1987 EZGO Marathon motor studs broke | Electric EZGO | |||
| Micro Switch issue or F & R switch. | Electric EZGO | |||
| ez-go micro switch | Gas EZGO | |||
| copper studs for FNR switch | Electric EZGO | |||
| Micro switch on fwd and rev switch has bee removed | Electric EZGO | |||
Linear Mode
