|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
05-31-2017, 08:15 PM | #1 |
Not Yet Wild
Join Date: May 2017
Posts: 9
|
Clutch and fan install
I have completely rebuilt my 295cc robin motor. Now how do I torque the clutch and fan back on? I can not figure out how to hold them. Thanks for any suggestions.
Sent from my SM-G930P using Tapatalk |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
05-31-2017, 10:42 PM | #2 |
Gone Wild
Join Date: Jun 2015
Location: NW Iowa
Posts: 1,669
|
Re: Clutch and fan install
MAKE SURE PISTON IS ON COMPRESSION STROKE (SO NO VALVES ARE OPENING) stuff clean rope down spark plug hole as piston comes up rope will stop it allowing you to torque both bolts and I repeat MAKE SURE ITS ON COMPRESSION STROKE if not it will bend valves
|
05-31-2017, 10:57 PM | #3 | |
Not Yet Wild
Join Date: May 2017
Posts: 9
|
Re: Clutch and fan install
Quote:
Sent from my SM-G930P using Tapatalk |
|
06-01-2017, 12:02 PM | #4 |
Nincompoop Club Member
Join Date: Jun 2016
Location: Idaho
Posts: 1,177
|
Re: Clutch and fan install
Great advice right there, I'll be doing the same thing soon. Thanks Spicy
|
06-01-2017, 12:36 PM | #5 |
Not Yet Wild
Join Date: May 2017
Posts: 9
|
Re: Clutch and fan install
It worked great. Fed about a foot of 1/4 inch rope into sparkplug hole. Torqued down fan then pulled rope reset for primary clutch did same thing.
Sent from my SM-G930P using Tapatalk |
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Gx390 clutch install | Big Block Talk! | |||
Clutch install trouble's | Big Block Talk! | |||
Comet clutch install ? | Gas EZGO | |||
Clutch install | Gas EZGO | |||
88 clutch install | Gas EZGO |