03-15-2013, 10:58 PM | #1 |
Not Yet Wild
Join Date: Feb 2013
Posts: 5
|
Hei on 82 ezgo
Hey everyone,new to the post and carts. What I need to know is on a 2pg is the HEI wireing the same as the 3pg that is on the stickey. Any info would be great.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-16-2013, 01:38 AM | #2 |
Gone Wild
Join Date: Feb 2011
Posts: 1,515
|
Re: Hei on 82 ezgo
Welcome to BGW YES same thing.
LOU |
03-16-2013, 09:59 AM | #3 |
Not Yet Wild
Join Date: Feb 2013
Posts: 5
|
Re: Hei on 82 ezgo
Thanks Lou. Having problems getting cart to start. I did top end rebuild and new crank seals. Engine looks like it has been worked on before so I'm not sure if pulsar ring is in the right place. I do get spark but won't hit.
|
03-16-2013, 07:46 PM | #4 |
Gone Wild
Join Date: Feb 2011
Posts: 1,515
|
Re: Hei on 82 ezgo
The pulse rplate should be centered with the two screws in the slots that will be close. Now have you replaced the plug ? If not do that and check the plug wire where it enters the coil. It unscrews from a pin post in the coil while it's out snip off about a 1/2 inch and reinsert it. Are you sure your getting fuel ?
|
03-16-2013, 08:50 PM | #5 |
Not Yet Wild
Join Date: Feb 2013
Posts: 5
|
Re: Hei on 82 ezgo
I should have been more clear on pulser. Should it be towards top of motor or bottom? Yes it has new plug and hei conversion. The plug seams to be wet when I pull it out.
|
03-16-2013, 09:46 PM | #6 |
Gone Wild
Join Date: Feb 2011
Posts: 1,515
|
Re: Hei on 82 ezgo
Left side or top looking at it. Also look for a timing mark on the pulser plate and housing. You may also try reversing the blue and red wires for the pulser and see if it will fire then sometimes the have to be reversed.
LOU |
03-17-2013, 08:07 AM | #7 |
Not Yet Wild
Join Date: Feb 2013
Posts: 5
|
Re: Hei on 82 ezgo
Ok it sounds like I did most of it right. I will get another new plug and see if that helps. I hope I didn't screw one thing up when I didn't replace jug on rebuild. It looked in real good shape and honed out pretty even.
|
03-17-2013, 08:23 AM | #8 |
Gone Wild
Join Date: Dec 2012
Location: Warren Mi
Posts: 233
|
Re: Hei on 82 ezgo
When I did the HEI on my 83 I ended up using a car coil,, the stock one would peter out after about 3 min of running.. I think it would get hot and die. the car coil blows a 3/4" spark now!! and runs great Good luck and keep us in the loop
|