|
|
|||||||
| Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
  |
|
|
Thread Tools | Display Modes |
04-15-2013, 08:27 PM
|
#1 |
|
Gone Wild
Join Date: Jul 2012
Location: Pigeon Forge TN
Posts: 209
|
How smooth does a g2 engine run?
My g2 starts good and seems to run good as far as power but it seems like it runs rough. Is that normal or should it be pretty smooth?
Bob T |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
04-16-2013, 01:57 AM
|
#2 |
|
Not Yet Wild
Join Date: Feb 2013
Location: So. IL
Posts: 18
|
Re: How smooth does a g2 engine run?
Not sure exactly what you mean, but I have an 87 g2 and it runs like a champ and is fairly smooth.
|
|
|
|
|
04-16-2013, 06:24 AM
|
#3 |
|
Gone Wild
Join Date: Jul 2012
Location: Pigeon Forge TN
Posts: 209
|
Re: How smooth does a g2 engine run?
It is hard to explain it. It is somewhat like a vibration. I am going to see if I can record it.
Bob T |
|
|
|
|
04-16-2013, 06:26 PM
|
#4 |
|
Gone Wild
Join Date: Jul 2012
Location: Pigeon Forge TN
Posts: 209
|
Re: How smooth does a g2 engine run?
See if this helps.
Bob T |
|
|
|
|
04-16-2013, 08:29 PM
|
#5 |
|
Vegas modded 420
 Join Date: Jun 2009
Location: West MI
Posts: 15,443
|
Re: How smooth does a g2 engine run?
The motor mounts are very good assuming they are not broken. They do have a tension cable under the gen pulley so the motor can't torque into the trans, it will transmit some vibration when you are gassing on it hard. Otherwise I'd say mine was very smooth, it never missed a beat. My clone is now on the same mounts and I can feel it a little but not much. It shakes more, it is a larger 420cc though. It mostly only shakes when I gas it at idle. The clutch can make noises and even vibrate if the center bushing is shot. You can move (tilt) the whole outer section by hand. Normally they have a little play but not a lot.
|
|
|
|
|
04-16-2013, 08:35 PM
|
#6 |
|
Gone Wild
Join Date: Jul 2012
Location: Pigeon Forge TN
Posts: 209
|
Re: How smooth does a g2 engine run?
I have new mounts and the cable is also new. The bushings have been replaced in the primary.
I made a video but can't get it to load. Bob T |
|
|
|
|
04-19-2013, 07:41 PM
|
#7 |
|
Gone Wild
Join Date: Jul 2012
Location: Pigeon Forge TN
Posts: 209
|
Re: How smooth does a g2 engine run?
|
|
|
|
|
04-19-2013, 09:02 PM
|
#8 |
|
Gone Wild
Join Date: Jun 2009
Location: ozarks
Posts: 237
|
Re: How smooth does a g2 engine run?
sounds good to me, only thing you might do is remove the gold cover on the front clutch and check the weights ,they might be loose on the pins
|
|
|
|
|
04-19-2013, 09:44 PM
|
#9 |
|
Smoov az a gravy sammich
Join Date: Oct 2008
Location: Limestone, Illinois
Posts: 3,462
|
Re: How smooth does a g2 engine run?
Yup! Sounds pretty decent to me also! The least you can do is change oil, and get a tune up kit for it...
|
|
|
|
|
04-19-2013, 10:08 PM
|
#10 |
|
Gone Wild
Join Date: Oct 2010
Posts: 6,730
|
Re: How smooth does a g2 engine run?
Do you know if the balance shaft has been removed from the motor?
|
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Smooth out the ride | Gas EZGO | |||
| G14 rear splined hub worn smooth | Electric Yamaha | |||
| g-1 not running smooth | Gas Yamaha | |||
| g1 can't get to run smooth | Gas Yamaha | |||
| Another new skin (Smooth) | Announcements | |||
Linear Mode
