no spark issues

[Sand Man]

still checking for cause of no spark , checking gas pedal switch I have 12 volts but when I press down pedal to start I have 0 volts coming out of the switch , I have read that if the oil pressure switch is not hooked up it will ground out the motor , I can not find a wire that goes to it can I just run a ground wire to it ? any help is as always greatly appreciated

[MOWERMAN1972]

I have a ergo gas and when the pedal is pushed I get a spark at plug and when the pedal is released I get a spark but not when it is turning over. Has anyone else had this problem would appreciate any kind of help

[meimk]

Lots of good information and test procedures in the "EZGO Gas Tech" section above the stickys. Specifically: http://www.buggiesgonewild.com/ezgo-...iagram-id.html
Look in section L for test procedures for the ignition parts.

[Sand Man]

I have read the manual for testing , I have also read that if the oil pressure switch is not plugged in it will ground out the engine does anyone know if this is true or have a comment on it ? I don't see any wires I have left off where would the wire come from for it ?