Got Issues need some help

[shallomac]

I have a 1979 ez-go with a 244cc 2pg robin 2-stroker. cannot get spark to the plug. Things I have done /replaced. Cleaned all contacts,replaced all wires,replaced points and condenser,new plug, both at proper gap settings,I bench tested the coil and it seems to fall in range. still no spark. I am getting 10.2 volts to the coil when engine is turning over. but no spark. the plug wire was tested and was reading 3 ohms which tells me that its good. could the coil still be bad even though it tested good? any ideas on what to try next will be highly appreciated.

[BrewCityMusic]

test the pulsar (red and blue wires coming from engine) with an ohmmeter, specs are 75ohms plus or minus 20 (so 55-95) ... it's prob good though if you're getting 10.2 to the coil. I'd try going with a different coil, search this topic for "cheap coil", I bought a replacement high-output coil on Ebay delivered for under $20 (and it eliminated the points and condenser, too)

[shallomac]

I pulled the engine out again, rechecked all the wiring, found the problem. Condenser was grounding out to the points, I re-routed the condenser wire dropped the engine back in and she fired right up. In my experience with this issue I came out with alot of knowledge of how this thing works.