|
04-11-2012, 08:35 AM
|
#11 |
|
Not Yet Wild
Join Date: Dec 2010
Location: Minneapolis, Kansas
Posts: 66
|
Re: 295 Rebuild
Well boys and girls she's up and running!! Whoot!!! Finally!! It took awhile with everything else going on around here.
Had the cylinders cleaned up and it actually didn't need bored at all! Still factory measurements! She runs like a champ! Smoked Real bad at first for about 30 minutes or so getting the rings to set in. Used some engine pre lube with moly graphite on the cylinder walls and I think it just took alittle while to burn that off. Doesn't hardly smoke at all now. Does anyone know the proper way to break these engines in?? Certain RPM for awhile and change every now and then?? Should get some pics of the engine loaded after a bit. Didn't get it to look as good as Ur's Crash but its clean and back to running! Thanks for everybody's help! This is the best site around!!  |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
04-12-2012, 07:51 AM
|
#12 |
|
Gone Wild
Join Date: Feb 2011
Posts: 1,515
|
Re: 295 Rebuild
OK enough!!! WHERES THE PICS
 |
|
|
|
 |
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| KF 82 Rebuild | Gas Club Car | |||
| 82 G 1 rebuild | Gas Yamaha | |||
| rebuild | Gas Club Car | |||
| G16 rebuild | Gas Yamaha | |||
| Buy Or Rebuild | Electric EZGO | |||
Linear Mode
