|
Electric Yamaha Electric Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
05-11-2016, 10:14 AM | #21 |
Gone Wild
Join Date: May 2012
Location: Rio Verde, Az
Posts: 7,170
|
Re: Looking for help please anyone
Not only that but I would say that Most of the problems here turn out to be either a bad battery or a bad cable connection to the batteries. Also, bad batteries lead to other failures because the voltage sags so much when you try to drive the cart.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
05-17-2016, 07:14 PM | #22 |
Not Yet Wild
Join Date: Apr 2011
Posts: 30
|
Re: Looking for help please anyone
Ok batteries charged and getting 36 volts to key switch!what should I get at pedal and what am I testing at pedal two wires going into what looks like a push button when pedal is pushed! Thanks again guys also found original key switch all together and should I get a click at pedal when pressed to move forward!
|
05-18-2016, 12:39 AM | #23 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Looking for help please anyone
pedal switch wires will be red and brown. one has pack B+ 36v when key is on, other has pack B+ when pedal is pressed.
|
05-18-2016, 04:57 AM | #24 |
Not Yet Wild
Join Date: Apr 2011
Posts: 30
|
Re: Looking for help please anyone
Ok have them what is pack b+ sorry don't understand?
|
05-18-2016, 01:33 PM | #25 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Looking for help please anyone
36v +
|
05-18-2016, 06:58 PM | #26 |
Not Yet Wild
Join Date: Apr 2011
Posts: 30
|
Re: Looking for help please anyone
Ok have 30. Volts when pedal pressed and 30 volts at all times so no 36 volts but have 36 across board!
|
05-19-2016, 06:57 PM | #27 |
Not Yet Wild
Join Date: Apr 2011
Posts: 30
|
Re: Looking for help please anyone
is there a way I can test motor? And also would the controller be one of the
Last things to check? Also have a parts g-16 will motor work if motor is junk on g-8 a lot of parts r the same a-arms some trim stuff few other minor stuff! |
05-19-2016, 09:26 PM | #28 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Looking for help please anyone
if axle is the same, motor will work. im still thinking its the mis-matched inputs (30v) or wiring somewhere myself.
|
05-20-2016, 05:11 AM | #29 |
Not Yet Wild
Join Date: Apr 2011
Posts: 30
|
Re: Looking for help please anyone
Ok like said put new forward reverse switch! Double checked that and seems to be good gonna goe threw again and check everything! Also how can I test motor to make sure it is good! Thanx again
|
05-20-2016, 05:13 AM | #30 |
Not Yet Wild
Join Date: Apr 2011
Posts: 30
|
Re: Looking for help please anyone
Also did new batterie wires and all that good stuff so if have too will double check everything!thanx
|