|
|
|||||||
| Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
  |
|
|
Thread Tools | Display Modes |
01-05-2017, 03:40 PM
|
#1 |
|
Not Yet Wild
Join Date: May 2016
Location: Southwest Florida
Posts: 71
|
Yamaha G16 more torque in reverse than forward?
Can someone help me out with my G16, Brand new primary clutch and secondary clutch and UMAXX spring but the cart is getting all the torque in reverse I really want the amount I get in reverse gear is what i want in forward, it would be exactly the power I am looking for, any help would be appreciated thanks
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
01-05-2017, 03:48 PM
|
#2 |
|
maintaining a low profile
 Join Date: Oct 2009
Location: SW Virginia USA
Posts: 6,314
|
Re: Yamaha G16 more torque in reverse than forward?
The reverse gear has a lower gear ratio...
|
|
|
|
|
01-05-2017, 07:35 PM
|
#3 | |
|
Sometime's............
Join Date: Oct 2007
Location: Tacoma Washington
Posts: 11,874
|
Re: Yamaha G16 more torque in reverse than forward?
Quote:
 You could get a Umax input shaft and a Umax forward gear...but you don't even want to know the cost |
|
|
|
|
|
01-07-2017, 10:51 AM
|
#4 |
|
Not Yet Wild
Join Date: May 2016
Location: Southwest Florida
Posts: 71
|
Re: Yamaha G16 more torque in reverse than forward?
I guess Ill have to deal with it then lol could you guys give advice on why my cart only runs on half choke? I installed newer carb, fuel filter, fuel pump, and sealed my airbox and still wont run correctly off choke.
|
|
|
|
|
01-08-2017, 02:59 PM
|
#5 |
|
Vegas modded 420
Join Date: Jun 2009
Location: West MI
Posts: 15,443
|
Re: Yamaha G16 more torque in reverse than forward?
Usually dirty carb, leak in airbox or intake spacer, or a modification for more air flow through airbox or exhaust. Last chance you can just richen the carb up to fix it by enlarging the main jet with a jet drill set or torch tip cleaners....enough to make it run right again. But I'd tell you try to fix the problem first if no mods or leaks it should run fine with stock clean carb when warm. If you take the fuel line off the carb it should spurt out every revolution when you turn it over, if so you have plenty of fuel it does not take that much to run it.
|
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Yamaha G1 goes in reverse but not forward | Gas Yamaha | |||
| Yamaha G2E Forward/Reverse Switch | Electric Yamaha | |||
| forward vs reverse. MAJOR difference in 'torque' | Electric EZGO | |||
| Yamaha g22 forward and reverse cables help | Gas Yamaha | |||
| yamaha g19 will go in reverse but not forward | Electric Yamaha | |||
Linear Mode
