Yamaha G9 starter/gen to VR wiring

[BareCpl]

I dropped a clone into my G9. I'm using the original starter generator. I am frustrated in trying to find the proper connections to make to hook to a 3 wire automotive regulator. Terminals are marked Bat, Gen, Field. I've poured over schematics and blogs but I can't find where the green and red wires go. I have tried multiple combinations from various schematics I've found but nothing works. The SG and VR are both new. The SG ohms out correctly between red and green wires. I;ve got a ton of hours in the conversion and all is satisfactory except I can't charge the darned battery. Any help would be greatly appreciated!

[smallblock450sl]

Best I can tell you... R/W D (+), Green (DF), and black D (-) or battery ground. Hope your regulator instuctions or that the vr is labeled as such.

[BareCpl]

That is my dilemma. I can't correlate between what you have and Bat, Gen and Arm.

[harrydm]

That regulator will not work. Just use the original Yamaha regulator and wire it up according to the proper wiring diagram. The red/white wire is hooked to a positive feed and the regulator grounds the green wire for regulation. If the Yamaha regulator is not available, I believe you can use a Chrysler voltage regulator as it also regulates in the same manor.
Dan

[BareCpl]

I'll check that out. Thank you!