|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
02-02-2010, 09:47 PM | #1 |
Not Yet Wild
Join Date: Jan 2010
Location: NorthWest
Posts: 22
|
G-14- piston ring end gap spec
Hey Guys & gals need a little help here.. Overhauling my G-9 4-stroke... Oversized the cylinder bore to fit a G-14 or 75.00 mm piston..standard piston/ring set.. Bore & hone turned out great .. I need the ring end gap spec. It seems that the standard ring has .010 gap...when installed & measured as usual..I know that a G-9 standard thru oversized set-up is .001-.004 inch any help on the book spec for standard G-14 ring end gap would be much appreciated. Thank You in advance...
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
02-03-2010, 08:52 PM | #2 | |
Sometime's............
Join Date: Oct 2007
Location: Tacoma Washington
Posts: 11,868
|
Re: G-14- piston ring end gap spec
Quote:
|
|
02-03-2010, 10:16 PM | #3 |
Not Yet Wild
Join Date: Jan 2010
Location: NorthWest
Posts: 22
|
Re: G-14- piston ring end gap spec
Thanks Dave, Appreciate the spec. and help. Wasn't sure if G-14 was going to be the same end gap. Thanks again
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
spec help needed | Gas Yamaha | |||
g16 valve lash spec | Gas Yamaha | |||
ring gap g1 | Gas Yamaha | |||
ring end gap | Gas EZGO | |||
Ring me | Announcements |