93 Club Car w/Alltrax Controller still not moving

[scottyb]

Originally Posted by pharris1034

The solenoid is clicking but I do not see an LED on my controller.

All Alltrax have LED status light on them. If you light is not lighting up you may not have power to pin #1 when you try to go? Check that out.....

[Epb]

The led is right next to the four smaller terminals. I can't see mine from under the cart so that is probably happening to you.

[pharris1034]

I apologize but I may have been wrong. I thought my controller was an Alltrax because I ordered it from Scottyb but it may not be. I'm trying to post a picture.

[pharris1034]

http://i1156.photobucket.com/albums/...g?t=1402438463

[Epb]

In the picture you are missing the connections on the fsip controller. Did u balance to the wiring diagram?

[Epb]

The smaller terminals are power (key) and throttle input so no hookup no go. Now Scotty should be back soon to correct me if I'm wrong. Or a slew of many others.

[pharris1034]

Yes I unplugged them just to clear the picture a little. To show that there was not an LED indicator.

[scottyb]

1. Verify that the solenoid clicks when you press the peddle & you have 36v (+) to pin #1 when the peddle is pressed.

2. verify your throttle signal goes from 0 to 5000 when the gas is pressed. Simply plug an ohm meter into the 2 output wires and press the gas.

3. have somebody help. put voltmeter test leads on B- and M-. have helper press the gas until the solenoid clicks and stop. you should read 36v. have helper continue pressing gas peddle down, you should see the voltage go down near 0.

4. If 36v at solenoid click between B- and M- on the controller and 1&2 have been verified but no decrease in voltage when the peddle is pressed, the control has failed.