RHOX Lift Kit

[Zorba1]

I purchased my 2011 Precedent with a RHOX LIFT-503 6" lift installed by a previous owner. When I recently installed HD rear springs, I noticed it is missing the centering plates (item f).
I contacted to ask if they are a necessity and if so can I order a pair. Told them the cart was purchased used and the lift kit was already on it.
Their reply was contact the retailer I purchased the kit from???? Replied to them but no response.
So my questions still stands.
1. Are the centering plates necessary?
2. If so, where can I get a pair?

[Htownblue]

The centering plates keep the assembly from shifting under force and attempts to keep the lift assembly in line with the various parts. The Rhox lifts use a two bolt system diagonally oriented and the centering plate helps the bracket which the bolts slide through from moving along the leaf spring / leaf spring axis.

Install (1) 6mm x 10 Hex Head Bolt and
(1) 6mm Nylock Nut onto the centering
plate. Place the centering plate between
the original shock mounting plate and
the leaf spring mounting perch on the
bottom of the axle. The 6mm bolt head
and nut will fit into the center hole of the
spring perch and original shock mounting
plate to aid in alignment of the riser
block and mounting plates.

you can make them
i think they are ¼" flat bar about 2 ½ x 4" with a 6mm hole centered

[NoleFan4Ever]

Originally Posted by crash test dummy

you can make them
i think they are ¼" flat bar about 2 ½ x 4" with a 6mm hole centered

That sounds dead on, but it might have been 5/16" flat bar, I don't remember, but either should work fine.

[Zorba1]

Thanks, easy enough to make. Better safe than sorry.