|
|
|||||||
| Electric Club Car Electric DS, and Precedent golf cars |
  |
|
|
Thread Tools | Display Modes |
10-07-2020, 08:11 AM
|
#41 |
|
Gone Wild
 Join Date: Sep 2012
Location: Charlotte, NC
Posts: 9,329
|
Re: Solenoid not engaging.
Based on your voltage readings I would agree that it is likely another bad controller or it does not have the correct throttle type setup.
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
10-07-2020, 08:23 AM
|
#42 |
|
Gone Wild
Join Date: Jun 2018
Location: Richmond,Virginia
Posts: 550
|
Re: Solenoid not engaging.
Good point never thought about the throttle setting. Could have saved a lot of time an money if OP would have just purchased a new Controller.
Sent from my iPhone using Tapatalk |
|
|
|
|
10-07-2020, 11:15 AM
|
#43 |
|
Gone Wild
Join Date: Jun 2018
Location: Richmond,Virginia
Posts: 550
|
Re: Solenoid not engaging.
Started going over all wires a pin location. Pin #9 is the gray to T/R switch. on this cart it is not on #9 it is on #11. Could that be problem.
|
|
|
|
|
10-07-2020, 11:26 AM
|
#44 |
|
Gone Wild
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 9,329
|
Re: Solenoid not engaging.
Pin #11 is unused in every club car 16-pin connector until the ERIC Controller used that for the SOC meter.
Pin #9 is the one You removed when you asked about how to remove a bad pin from the connector on the beginning of this thread.... If it in on pin #11 now you must have put it there by accident when you replaced it. |
|
|
|
|
10-07-2020, 11:43 AM
|
#45 | |
|
Gone Wild
Join Date: Jun 2018
Location: Richmond,Virginia
Posts: 550
|
Re: Solenoid not engaging.
Quote:
 |
|
|
|
|
|
10-07-2020, 11:44 AM
|
#46 |
|
Gone Wild
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 9,329
|
Re: Solenoid not engaging.
That pin powers the Controller, the KSI input is just a low current signal.
|
|
|
|
|
10-07-2020, 12:19 PM
|
#47 |
|
Gone Wild
Join Date: Jun 2018
Location: Richmond,Virginia
Posts: 550
|
Re: Solenoid not engaging.
Switch gray wire from #11 to #9. Up and running.
THANKS Sergio |
|
|
|
|
10-07-2020, 07:00 PM
|
#48 | |
|
Gone Wild
Join Date: Jun 2018
Location: Richmond,Virginia
Posts: 550
|
Re: Solenoid not engaging.
Quote:
 |
|
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| 2003 Club Car DS solenoid not engaging | Electric Club Car | |||
| Solenoid not engaging | Electric Club Car | |||
| Solenoid not engaging with Forward / Reverse switch? (Solenoid is good) | Electric EZGO | |||
| Ezgo PDS won't move, solenoid not engaging. | Electric EZGO | |||
| Solenoid not engaging; Potentiometer? | Electric Club Car | |||
Linear Mode
