|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
10-09-2013, 08:08 PM | #1 |
Not Yet Wild
Join Date: Sep 2013
Posts: 36
|
no amps to solenoid
Installed second solenoid, we have volts throughout cart, but no amps to the solenoid. Just curious why?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
10-10-2013, 05:00 AM | #2 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: no amps to solenoid
No Amps = No complete circuit
|
10-10-2013, 05:53 AM | #3 |
Not Yet Wild
Join Date: Sep 2013
Posts: 36
|
Re: no amps to solenoid
We took out my new spm 300 amp controller, installed the original on my 95 medalist. We get solenoid to click with old controller. You think its programmed wrong? Or just a bad controller?
|
10-10-2013, 06:29 AM | #4 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: no amps to solenoid
What does the LED do when the pedal is pushed? (Should be 4 green blinks, then solid green when programmed for an EZGO ITS throttle system.)
It is a SPM48300, SPN48300P or a SMP48300EZ? Did you attach the Black wire from the solenoid to the "RLY COIL -" terminal on the SPM controller or leave it connected to the B+ terminal? |
10-10-2013, 06:33 AM | #5 |
Not Yet Wild
Join Date: Sep 2013
Posts: 36
|
Re: no amps to solenoid
When we push the pedal it blinks 4 green.... the 1 green and 6 red.... "pre charge failure" We tested the resistor its good, reads at 227 ohms.... The controller I have is SPM48300EZ ITS and yes we disconnected black wire and installed it to -RLY coil
|
10-10-2013, 08:16 AM | #6 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: no amps to solenoid
Measure the voltage on the controller's B+ terminal. It should be a few volts less than full battery pack voltage when the solenoid isn't energized.
If the voltage is right, I think it is time to give Alltrax a call. |
|
|
Similar Threads | ||||
Thread | Forum | |||
Winch Amps and Voltage Reducer? How many amps can I draw? | Electric EZGO | |||
Resistor amps vs stock controller amps | Electric Club Car | |||
How many amps does the Solenoid have to be rated for? | Electric EZGO | |||
How many AMPS is a Gas Powered EZGO solenoid? | Gas EZGO | |||
amps, how many? | Gas EZGO |