|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
11-27-2009, 09:22 PM | #1 |
Gone Wild
Join Date: Nov 2007
Posts: 469
|
Modifying Governor on G16 & G22
Here is a way to modify your governor to be wide open without having to play around try to figure out how to re align the throttle cables
1- Loosen the 10mm nut if you already have it cranked up , (it need to be stock) 2- Remove the plastic black cover at the back & remove the basket if you still have one At the lower part of the governor there is a bolt with a 10mm nut you loosen it so you can pry up the governor about 1/4 of an inch of the shaft you will notice that it is D shaped you take a 5/16 drill bit & round up the bracket so it will spin freely on the shaft Put it back in place Use a little lock tight or nail polish on the bolt & just tighten it by hand to keep from loosing it This way you have full throttle no restriction & all runs smooth like before, Change you oil to synthetic 1 liter of 10w30 Very important don’t hold it to the floor going downhill not to blow it up Good Luck Cart de Golf this might work on other models I havent tryed it Last edited by cart de golf; 11-27-2009 at 09:23 PM.. Reason: more info |
|
|
Similar Threads | ||||
Thread | Forum | |||
Governor question | Gas Yamaha | |||
88 ez go governor | Gas EZGO | |||
governor | Gas Club Car |