Back Road Buggy II Build

[rammunition361]

Same **** different cart.

Now that I got my booger hooks on a gas cart im stripping the sparky and building the 99 TXT.

Ordered LED light kit for it, 6098 belt and unfortunately a fuel pump

What is the model of the motor in this cart???

Also if yall care to know im swapping my Steeleng Lift to the gas, I reckon they are compatible gas or electric. Ill put the 23's on for now as well and ive already pulled the bed and top. Went ahead and tightened governor while I was in there, hope its right cause once the beds on......

anyway ill post pics sometime, going on a mini vaca this weekend and ill be crushin coors light so maybe next week.

[BrewCityMusic]

if You use the electric Steeleng kit on a gasser You'll have to flip the backing plates on the brakes side-to-side so the cables are on the bottom to get clearance, otherwise it will work just fine, You *may* have to swap the tie rod from above the spindles to below also (some of their drop-axle kits are wonky that way, depending on the generation You have) ... A 1999 TXT should have the Fuji-Robin 295cc in it. Have fun with the swap!

[rammunition361]

Thanks that will help a lot. They said I had to drill out a few holes

[rammunition361]

got my bed swapped over off the medalist. broke a bolt off on the 99 trying to take the front roof mount off. Been drilling on it for awhile, broke off flush with the plastic. Hopefully I can get that drilled and tapped this week and my fuel pump will come in. Front headlights are cut in but I have to figure out what to do with the splash shield under the cowl, I haven't seen anybody mention having a problem with it but it is right in the way.

[rammunition361]

Originally Posted by BrewCityMusic

if You use the electric Steeleng kit on a gasser You'll have to flip the backing plates on the brakes side-to-side so the cables are on the bottom to get clearance, otherwise it will work just fine, You *may* have to swap the tie rod from above the spindles to below also (some of their drop-axle kits are wonky that way, depending on the generation You have) ... A 1999 TXT should have the Fuji-Robin 295cc in it. Have fun with the swap!

im assuming you've done this swap before? im almost considering buying another lift. Just because I just installed this one lol

[rammunition361]

bit the bullet and bought the jakes 6" spindle for the new cart. If the other don't sell ill keep it and I want it lifted lol

[rammunition361]

got the lift installed, minus rear tires

[rammunition361]

picked up napa 6098 belt today, also got a 2500lb winch for the cart. The gf absolutely hates both of these carts now. Ive got around 4k in them and ive had them 2 months

[rammunition361]

LED light bar and LED headlights are installed, Have to run some wires for headlights yet but this joker is LED EVERYTHING! Gonna light up the night boys and girls. I have snapped some pics and will upload when I get finished up

[rammunition361]

Alright, here are some current pics, 20" LED light bar 9600 lumens, and the led head light kit installed with my clay basket.