|
|
|||||||
| Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
04-20-2013, 09:44 PM
|
#1 |
|
Gone Wild
Join Date: Mar 2010
Location: So GA
Posts: 237
|
ISO Mount flip for lift kit
How do you get it loose from the axle? Bolts are out, is there a trick to getting it off or loose enough to flip so the rear springs/blocks to go on top of the axle?
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
04-20-2013, 09:51 PM
|
#2 |
|
Gone Wild
Join Date: Oct 2010
Posts: 6,730
|
Re: ISO Mount flip for lift kit
The iso-mount and bushing should just lift off. You may have to pry it a bit.
|
|
|
|
|
04-20-2013, 10:02 PM
|
#3 |
|
Gone Wild
Join Date: Mar 2010
Location: So GA
Posts: 237
|
Re: ISO Mount flip for lift kit
Ok, I pulled on it for a few minutes, it was real tight, couldn't get it over the pin on top of the axle. I didn't have much time, I'll try it tomorrow.
|
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Steering-rod flip after lift... | Gas EZGO | |||
| flip | Test Post | |||
| flip | Test Post | |||
| Flip The Swingarm On A G1 | Gas Yamaha | |||
| EZGO Flip? | Lifted Golf Carts | |||
Linear Mode
