|
|
|||||||
| Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
09-13-2013, 09:29 AM
|
#1 |
|
Not Yet Wild
Join Date: Aug 2013
Posts: 32
|
88 2PG Crankshaft - Think it will seal?
It looks like the oil seals cut some circular grooves in the shaft. The rod seems good, so I was hoping I could save the shaft, but the grooves have me worried. I think they are smooth enough that they won't tear up a seal, but I'm not sure if the groove will leak. See the picture. Anyone have thoughts on this?
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
09-13-2013, 01:59 PM
|
#2 |
|
Gone Wild
Join Date: May 2012
Location: Rio Verde, Az
Posts: 7,173
|
Re: 88 2PG Crankshaft - Think it will seal?
That should be cleaned up. It will chew up the seals.
|
|
|
|
|
09-13-2013, 02:38 PM
|
#3 |
|
Not Yet Wild
Join Date: Aug 2013
Posts: 32
|
Re: 88 2PG Crankshaft - Think it will seal?
Ok. After most is cleaned up there will still be a groove from the old seal. Any idea if the new seal can deal with it?
Last edited by Ninjaneer; 09-13-2013 at 02:45 PM.. Reason: Better graphic |
|
|
|
|
09-13-2013, 08:29 PM
|
#4 |
|
Gone Wild
 Join Date: Jul 2013
Location: kansas city, mo
Posts: 323
|
Re: 88 2PG Crankshaft - Think it will seal?
If ur going to keep the cart long term. I would replace it. Its not that much more to have a complete new motor.
|
|
|
|
|
09-13-2013, 10:22 PM
|
#5 |
|
Gone Wild
Join Date: May 2012
Location: Rio Verde, Az
Posts: 7,173
|
Re: 88 2PG Crankshaft - Think it will seal?
Those marks don't look all that deep to me. It may clean up fine and still seal.
|
|
|
|
|
09-14-2013, 06:05 AM
|
#6 |
|
Gone Wild
Join Date: Feb 2011
Posts: 1,515
|
Re: 88 2PG Crankshaft - Think it will seal?
Have you thought about the possibly of double sealing that side. The reason I ask is on a rebuild I did I over drove the seal OPPS and it appeared I could have stacked a second seal to be about flush with the case without interference inside. On a side note I did remove the seal and installed a new one so
 but that would move the sealing area to a new location. Am I thinking to much LOU |
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Question about Crankshaft Seal | Gas EZGO | |||
| Crankshaft seal installation? | Gas Columbia ParCar | |||
| Duromax Crankshaft Oil Seal | Gas Yamaha | |||
| Crankshaft Seal 89 EZGO | Gas EZGO | |||
| Crankshaft Seal Problem | Gas EZGO | |||
Linear Mode
