|
01-27-2019, 01:16 PM
|
#1 |
|
Not Yet Wild
Join Date: Jan 2019
Posts: 2
|
16 circuit plug
Good morning, I have 2002 cart, sn AQ0208-122561. It has a bad connection at the controller, wont run unless I wiggle the the sixteen wire plug. I have a new plug and pins ordered. Is there any other way to repair this connection. The cart is all stock.
Thanks for your help Rick |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
01-27-2019, 01:23 PM
|
#2 |
|
MOD of all BS!
 Join Date: Sep 2011
Location: Florida
Posts: 17,477
|
Re: 16 circuit plug
That is a 2002 IQ (Sepex) cart. That is a Curtis 16pin connector and if you flip to Tow on the Run/Tow switch, disconnect the Main Pack Negative, then pull the connector. You can inspect each pin and see if one is lose or what the problem is. Sometimes you can just pull it, clean it with electrical contact cleaner, and reinstall it and it will work fine. If not then you need to locate the lose pin and remove it and reseat it in the connector so it is tight.
|
|
|
|
|
01-27-2019, 03:18 PM
|
#3 |
|
Not Yet Wild
Join Date: Jan 2019
Posts: 2
|
Re: 16 circuit plug
I have the tool ordered to remove the pins when I get it I will try your suggestion.
Thanks for the input. |
|
|
|
 |
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Installed AC plug port in factory plug location | Electric Club Car | |||
| G1 turns over without plug, barely with plug in | Gas Yamaha | |||
| Charger plug and cart plug redo | Electric EZGO | |||
| Stripped out oil plug drain plug | Gas Yamaha | |||
| blinker light plug where to plug in | Electric Yamaha | |||
Linear Mode
