|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
12-14-2015, 12:42 PM | #1 |
Getting Wild
Join Date: Dec 2015
Location: South Florida
Posts: 80
|
48V solenoid replacement
Trying to replace the solenoid to get my cart running. When I purchased the cart, it was missing the solenoid as well as all the batteries, so did not have a reference.
A bit confused. Does the yellow wire off the B+ on controller go to the right stud on the solenoid that is noted with the "+" on the solenoid or does the battery cable get hooked up to that stud? Then the blue/white wire of the controller wiring harness gets connected to the tab located on the same side as where the yellow wire was installed. The light blue wire to the tab located on the same side as the battery cable installed. The Orientation seems different to me when you put the solenoid on the cart, the stud noted by the "+" seems to be on the same side of as the OBC. Note the diagram states- Solenoid Rotated 180^ |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
G1 solenoid repair rather than replacement | Gas Yamaha | |||
Yamaha G1E Solenoid Replacement | Electric Yamaha | |||
Solenoid replacement...again | Electric Club Car | |||
Solenoid Replacement | Gas EZGO | |||
Solenoid Replacement | Electric Club Car |