New Toys!!

kab69440 · 07-12-2012, 03:08 PM

You have the two hot leads spliced together. This drove me batspit crazy for about half an hour until I figured it out. Left turn- four way, right turn- four way, four way- four way. Arrrgh!

kab69440 · 07-12-2012, 03:14 PM

Oh, and when you decide to add a brake light switch... The power does not get supplied from the TS unit... You run a hot to the switch and THEN to the TS assy. Just a future FYI...

Just out of curiosity, what are you using for turn blinkers? I found a pair of two bulb trailer running lights that fit my clays basket perfectly. I paralleled a hot from the headlights to the inside bulbs and hooked them up in series(so they only get 6v each) and then ran 12v to the outboards that is powered from the TS unit. The effect given in low light is a glow from the marker at all times and when you hit the blinker it really lights up and grabs attention!

Dela · 07-12-2012, 04:01 PM

My cart has factory lights, had the "quick clip" cable under cup holder, looking at the diagram I may need to run a wire from tail to tail. Also unsure if wires in harness are correct with blinker wiring.

Gonna play with it tomorrow. Happy to have the new shocks on. Sitting nice and straight now.

I got lucky, wifey said cart looked like it was leaning. "time for new coil overs then!".

kernal · 07-12-2012, 04:19 PM

Quote:

Originally Posted by Dela

Got the blinker kit installed, but only hazards work... any ideas boys?

I did notice that my front right bulb is out, but both lefts blink with hazard but not with left blinker on...

thoughts?

If this is a factory signal kit you have to swap some wires on the tail lights. Instructions are available in pdf from the shopezgo site. If this is not a factory kit some sites sell an adapter kit to mate up with the factory harness. Other than that IDK.

Dela · 07-12-2012, 04:50 PM

Thanks kernal! I'll try to locate it later, it is factory so the PDF should help.

1BDPRECEDENT · 07-12-2012, 05:37 PM

Where did you get your coilovers?

Dela · 07-12-2012, 06:03 PM

I went through Fanklin golf cars, came quick with all hardware needed. I shop a LOT prior to purchasing and this was the cheapest route.

Dela · 07-13-2012, 05:33 AM

Kernal - just went to the shop ezgo site, they want $68 for the manual?!?!

not gon do it - wuldn't be prudent...

any other place to get it fo' free?

....how much for one rib?

Dela · 07-13-2012, 06:04 AM

Ok, found it - no worries. Bing Bam Boom, put this wire here, put that one there - blinkers are working and I am

Thanks again Kernal!

attached for whoever needs in the future - if you can't open the attachment go here - http://goo.gl/VV99I

07-12-2012, 03:08 PM	#11
kab69440 Gone Wild Join Date: Aug 2010 Location: Marion, Ohio Posts: 1,391	Re: New Toys!! You have the two hot leads spliced together. This drove me batspit crazy for about half an hour until I figured it out. Left turn- four way, right turn- four way, four way- four way. Arrrgh!

07-12-2012, 03:14 PM	#12
kab69440 Gone Wild Join Date: Aug 2010 Location: Marion, Ohio Posts: 1,391	Re: New Toys!! Oh, and when you decide to add a brake light switch... The power does not get supplied from the TS unit... You run a hot to the switch and THEN to the TS assy. Just a future FYI... Just out of curiosity, what are you using for turn blinkers? I found a pair of two bulb trailer running lights that fit my clays basket perfectly. I paralleled a hot from the headlights to the inside bulbs and hooked them up in series(so they only get 6v each) and then ran 12v to the outboards that is powered from the TS unit. The effect given in low light is a glow from the marker at all times and when you hit the blinker it really lights up and grabs attention!

07-12-2012, 04:01 PM	#13
Dela EZ come EZ go Join Date: Apr 2012 Location: Parkland FL Posts: 1,412	Re: New Toys!! My cart has factory lights, had the "quick clip" cable under cup holder, looking at the diagram I may need to run a wire from tail to tail. Also unsure if wires in harness are correct with blinker wiring. Gonna play with it tomorrow. Happy to have the new shocks on. Sitting nice and straight now. I got lucky, wifey said cart looked like it was leaning. "time for new coil overs then!".

07-12-2012, 04:50 PM	#15
Dela EZ come EZ go Join Date: Apr 2012 Location: Parkland FL Posts: 1,412	Re: New Toys!! Thanks kernal! I'll try to locate it later, it is factory so the PDF should help.

07-12-2012, 05:37 PM	#16
1BDPRECEDENT Gone Wild Join Date: Feb 2011 Location: Corpus Christi, TX Posts: 795	Re: New Toys!! Where did you get your coilovers?

Today
BGW	Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

07-12-2012, 06:03 PM	#17
Dela EZ come EZ go Join Date: Apr 2012 Location: Parkland FL Posts: 1,412	Re: New Toys!! I went through Fanklin golf cars, came quick with all hardware needed. I shop a LOT prior to purchasing and this was the cheapest route.

07-13-2012, 05:33 AM	#18
Dela EZ come EZ go Join Date: Apr 2012 Location: Parkland FL Posts: 1,412	Re: New Toys!! Kernal - just went to the shop ezgo site, they want $68 for the manual?!?! not gon do it - wuldn't be prudent... any other place to get it fo' free? ....how much for one rib?

Similar Threads
Thread	Forum
My ATV and SXS Toys	Side x Sides/ATVs/Quads/Bikes/Jeeps/4x4's!
Where does he get those fabolous toys...	Members Rides
The Toys	Members Rides
my toys	Members Rides
My Toys	Videos