2001 Electric Club Car wont go

[Sergio]

Originally Posted by wntrdgfrm

When i crossed over the two big posts on the solenoid...shouldnt that have bypassed the controller?

You must meant the solenoid activation circuit as you cannot bypass the controller itself. The logic side of the controller appears to be working since the reverse buzzer comes on.
You said you replaced the OBC, make sure the black wire from the OBC is plugged to the B- on the controller. The OBC is part of the lockout circuit for the solenoid. You can also plug the charger and see if it comes on, if not, the OBC is not working properly.

[wntrdgfrm]

Black wire is hooked...and I did try hooking charger up...it worked..

[wntrdgfrm]

Originally Posted by crash test dummy

check the in line fuse

The electrical diagram is a little different than my cart..i think..

the only fuse that I can find is in a gray wire with yellow fuse holder that goes from charger receptacle to the OBC.

Is there another inline fuse that I am missing?

My tow haul switch just seems to plug into a two wire plugin connector. I didn't see a fuse there.

i would say follow the pink wire ...
can you post your seral number ?

[wntrdgfrm]

I havent saw a pink wire yet..

Serial #
AC0117-012163

ok i only have that diagram ... none for the 6 x 8v

[wntrdgfrm]

Thanks...
Alot of the info is probably the same.

[Sergio]

This wiring diagram should match your cart....

[wntrdgfrm]

Originally Posted by Sergio

You must meant the solenoid activation circuit as you cannot bypass the controller itself. The logic side of the controller appears to be working since the reverse buzzer comes on.
You said you replaced the OBC, make sure the black wire from the OBC is plugged to the B- on the controller. The OBC is part of the lockout circuit for the solenoid. You can also plug the charger and see if it comes on, if not, the OBC is not working properly.

Could you explain to me how the solenoid action circuit works or how to test it?

[wntrdgfrm]

Originally Posted by Sergio

This wiring diagram should match your cart....

Yes...this is the correct wiring diagram..

Thanks