Putting airbox, and carb back on 295cc 01 cart

[TXEZGO]

Ok...let me start by saying that I think whoever had this cart before me screwed this up and this is why I want to make sure I get it right.

When I took everything off to get to the carburetor, there were what seemed to be missing parts and gaskets....this may be why the air box seems to have melted around where it attaches to the carburetor.

I have figured out that I probably have a bad carburetor, but while looking for a replacement, I have noticed that Im missing a few things... What I would like to know is the order of things starting with gasket between carb and engine....

I think it goes like this:

gasket between carb/engine
carburetor
gasket between steel choke plate and carb
another gasket between steel choke plate and spacer???
gasket between spacer and air filter.
air filter box.
carb plate (im not sure what this is called, but its a small square metal plate inside airbox)
air filter
and finally cover.

Is this right? my cart was missing alot of gaskets, and had no carb spacer which is why I think the airbox melted.

Any help would be appreciated. I have bought a new air filter box, and want to get the spacer if needed to prevent this from happening again.

Thank you.

[popatop]

Hi TXEZGO, Look on Page E-14, Fig E-9 should help
http://products.jacobsen.com/img/manuals/27615-g01.pdf