|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
06-17-2013, 09:48 PM | #11 |
Not Yet Wild
Join Date: Jun 2013
Location: Michigan
Posts: 10
|
Re: Yamaha G14 bent push rod
took rockers off sat push roand theds on there spot. Turned over motor by hand. The rod on the passenger side comes up higher.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-17-2013, 10:30 PM | #12 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Yamaha G14 bent push rod
i dont have the manual (or valve lift specs) here, i will post them tomorrow. try to measure them both on the pushrod side tonight. i'll check the manual at the shop in the morning. now that the rockers are off, if you spin it does it have any compression/resistance?
|
06-17-2013, 10:59 PM | #13 |
Not Yet Wild
Join Date: Jun 2013
Location: Michigan
Posts: 10
|
Re: Yamaha G14 bent push rod
yes it does have resistance still. thanx btw.
|
06-18-2013, 07:34 PM | #14 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Yamaha G14 bent push rod
.208" intake, .209" exhaust lift when measured on the pushrod side of the rocker arm.
|
06-26-2013, 07:05 PM | #15 |
Not Yet Wild
Join Date: Jun 2013
Location: Michigan
Posts: 10
|
Re: Yamaha G14 bent push rod
k so a valve wasnt seated properly. should a lot of oil be coming out of the house off the front of the valve cover? the one that goes to the air box.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
82 Yamaha G1 needs a push to run? | Gas Yamaha | |||
Yamaha g9 push rod | Gas Yamaha | |||
CarryAll Suzuki '96 no idle? Only push to go, push to reverse or stalls | Gas Club Car | |||
G9/J38 Bent Push Rod | Gas Yamaha | |||
bent push rod | Big Block Talk! |