Alltrax Wiring for G19

[Geemonty]

I just purchased a an Alltrax controller to replace the dead stock controller on my yamaha g19. I was wiring it up and then noticed that 2 different wiring diagrams came with the controller. They both look like they should work but was curious if one would cause more wear or something on the controller/motor.

Another wiring concern I had is about the solenoid. Does anyone know if these are directional at all? It looks like I just need the diode on the small poles looking at the alltrax wiring diagram. Do I need the resistor or a diode(have one for my club car) on the large poles?

Was going to call alltrax support they are great but its the weekend so they are closed and was hoping to get it running before monday.

[ojo]

Just the diode on small posts, the Alltrax has the resistor inside.

[scottyb]

Follow the diagram that matches your stock controller make.
Only the correct diagram will work for your cart.
One diagram is marked for GE controls other for Moric controls

[Geemonty]

Originally Posted by scottyb

Follow the diagram that matches your stock controller make.
Only the correct diagram will work for your cart.
One diagram is marked for GE controls other for Moric controls

So the first picture is of the booklet it was the one I was following it is as you said marked as GE Controls. I happened to see the other paper sent which was basically all the same but it has the motor -/+ connecting differently to the controller. So I follow the diagram on the first pic I attached? Also does the direction matter on the solenoid that things are connected? This solenoid was ordered awhile ago and has no documentation at all. Do I just make sure the diode is wired correctly with respect to where I put the positive on the small posts?

[Geemonty]

Everything's working great, just need to install the battery meter I also ordered and I'm set. Thanks for responses.