|
12-13-2011, 10:59 PM
|
#11 |
|
Not Yet Wild
Join Date: Nov 2011
Posts: 7
|
Re: No 4th Speed
Should I replace all of them at the same time or is it o.k. to replace just the one?
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
12-13-2011, 11:11 PM
|
#12 |
|
Happy Carting
 Join Date: Dec 2007
Location: Southern California
Posts: 73,417
|
Re: No 4th Speed
You can replace one. part #1113 at most any golf cart supply, pick one of the sponsors from the list above . Some have automated sites you can just punch that # in and have it sent to you.
|
|
|
|
|
12-14-2011, 08:16 AM
|
#13 |
|
Mr. Helper
Join Date: May 2009
Location: NY Catskills & South carolina
Posts: 445
|
Re: No 4th Speed
Before you remove any wires... use white tape and number the wires. Then use your cell phone and take a picture....
not saying you need to do this.....but an ounce of prevention is worth a pound of cure |
|
|
|
|
12-14-2011, 08:27 AM
|
#14 |
|
The Last Moja Morani
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
|
Re: No 4th Speed
as mentioned you can replace just the one but if you can afford it why not do all of them? they are the same age and theres always that chance that another one will go and if you have all new ones you,ll end up with some good spares for the future.........make sure you buy 36 volt golfcart solenoids...................it will also be a good time to just take your time and clean up all your hardware and resistor coils...........................
 |
|
|
|
|
12-14-2011, 08:58 AM
|
#15 | |
|
Gone Wild
Join Date: Aug 2011
Location: Bunnell, Florida
Posts: 2,408
|
Re: No 4th Speed
Quote:
 |
|
|
|
|
|
12-14-2011, 09:47 AM
|
#16 |
|
The Last Moja Morani
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
|
Re: No 4th Speed
any time i touch a cart the 1st thing that walks to the cart with me is a roll of good duct tape..............matter of fact most of my tools are either dipped in plastic dip or wrapped in duct tape the only part of tool exposed is the part i need ........................so yes get yourself a roll of tape either duct tape or elec. tape and keep in in your glove box............................
|
|
|
|
|
12-14-2011, 09:57 AM
|
#17 |
|
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,417
|
Re: No 4th Speed
Shadowman approaches the golf cart ......
 |
|
|
|
|
12-14-2011, 10:05 AM
|
#18 | |
|
Medicare Recipient
Join Date: Jun 2011
Location: West Michigan
Posts: 3,541
|
Re: No 4th Speed
Quote:
|
|
|
|
|
|
12-14-2011, 11:08 AM
|
#19 | |
|
The Last Moja Morani
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
|
Re: No 4th Speed
Quote:
LOLOL.............don,t laugh to loud or long did you see that myth busters show where they made a boat completly out of duct tape and a bridge and some other stuff................but yeah scotty that hit the spot ............................ ............ |
|
|
|
|
|
12-14-2011, 11:11 AM
|
#20 |
|
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,417
|
Re: No 4th Speed
You have had the same avatar for a long time
 |
|
|
|
 |
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| MCOR? Speed Sensor? Controller? Cart Runs at half speed. Advice, please. | Electric Club Car | |||
| 08 precedent electric speed sensor problem. Cart starts at proper speed then slows . | Electric Club Car | |||
| Half speed, speed sensor problem?. | Electric Club Car | |||
| high speed gears with emp 2 speed, advice please | Electric EZGO | |||
| 1985 G1 Runs fine low speed , high speed run for a mile then fall on its face | Gas Yamaha | |||
Linear Mode
