|
10-25-2013, 10:47 PM
|
#1 |
|
Not Yet Wild
Join Date: Oct 2013
Posts: 2
|
How to maximize speed
Hello everyone. I have a 2010 gas rxv. my first question is does anyone have any feedback on the 8:1 speed gear. I am trying to maximize my cart. I am installing the erlandson clutch kit along with 205/35/14 tires. Does anyone know how to adjust throttle cable. I have been tinkering with it and have notice a backfire when I stop. What could be the cause. thanks in advanced
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
10-26-2013, 07:38 AM
|
#2 |
|
Gone Wild
Join Date: Jul 2013
Location: Juliette GA
Posts: 271
|
Re: How to maximize speed
If you have backfire then the linkage to the carb from the governor is being held too tight. If you adjusted the slack out of the throttle cable you might have gone too far. Don't know much about the gears on a gas cart, the electrical ezgo section has some info on gears. Do they make gears for a gas cart?
|
|
|
|
|
11-02-2013, 03:16 PM
|
#3 |
|
Gone Wild
Join Date: Jun 2008
Location: Raytown, Missouri
Posts: 894
|
Re: How to maximize speed
This Might Help http://www.buggiesgonewild.com/ezgo-...ntainance.html
|
|
|
|
 |
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| MCOR? Speed Sensor? Controller? Cart Runs at half speed. Advice, please. | Electric Club Car | |||
| 08 precedent electric speed sensor problem. Cart starts at proper speed then slows . | Electric Club Car | |||
| 1981 club car slow speed fast speed | Electric Club Car | |||
| high speed gears with emp 2 speed, advice please | Electric EZGO | |||
| 1985 G1 Runs fine low speed , high speed run for a mile then fall on its face | Gas Yamaha | |||
Linear Mode
