![]() |
|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
![]() ![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Not Yet Wild
Join Date: Mar 2014
Posts: 4
|
![]() I have a 2002 ezgo. I just replaced the brushes in the motor. It has been sitting for awhile before I fixed it. When I put the direction switch in forward the cart backs up. When I place the switch in reverse I hear the solenoid click but it does not move. The batteries are good and fully charged. I'm at a loss. Any help would be greatly appreciated. Thanks
|
![]() |
![]() |
![]() |
|
![]() __________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
![]() |
#2 | |
Not Yet Wild
![]() Join Date: Jan 2014
Location: South Carolina
Posts: 44
|
![]() Quote:
I'm not a golf cart expert by a long shot, but if it were me, I'd double check that all the wires are connected to the correct places. |
|
![]() |
![]() |
![]() |
#3 |
Techno-Nerd
![]() ![]() Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
![]() Could be two separate problems.
1. Runs in Reverse when direction selector in in Forward. Either the A1 & A2 cables or the S1 & S2 (or F1 & F2 cables if it is a Sepex motor) were reversed when they were reinstalled. 2. Runs in one direction, but not the other. What is causing this problem depends on which type drive system you have PDS or Series. Figure out what you have from the attached chart, let us know and we'll proceed from there. |
![]() |
![]() |
![]() |
#4 |
Not Yet Wild
Join Date: Mar 2014
Posts: 4
|
![]() I have the PDS.
|
![]() |
![]() |
![]() |
#5 |
Techno-Nerd
![]() ![]() Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
![]() Ouch, the F/R switching is done by the controller. (Reverses direction of current flow through the Field windings)
You might have a bad controller. Hopefully, you put the Run/Tow switch in Tow while disconnecting and reconnecting the motor cables. |
![]() |
![]() |
![]() |
#6 |
Not Yet Wild
Join Date: Mar 2014
Posts: 4
|
![]() Thanks guys. Is there a way to test the system with a multi meter?
|
![]() |
![]() |
![]() |
#7 |
Happy Carting
![]() ![]() Join Date: Dec 2007
Location: Southern California
Posts: 73,973
|
![]() If it's going in the wrong direction in one selection and not moving in the other selection it's a common controller failure like Johnnie said. Time for an upgrade.
|
![]() |
![]() |
![]() |
|
Thread Tools | |
Display Modes | |
|
![]() |
||||
Thread | Forum | |||
forward/reverse switch change to toggle switch | Electric Club Car | |||
83 Forward Reverse Switch | Electric Club Car | |||
Forward & Reverse switch | Gas EZGO | |||
97 TXT Forward Reverse Switch | Electric EZGO | |||
Forward Reverse switch melted on forward...have question about replacement part | Electric Club Car |