|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
10-25-2009, 09:03 PM | #1 |
Not Yet Wild
Join Date: Oct 2009
Posts: 8
|
1990 EZ GO Caburetor rebuild kit
Does anyone know where I can fine a rebuild kit for the Carb, I have found them for other years but not one for the 1990. Also need to know how to adjust carb after it is rebuilt
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
10-26-2009, 12:30 PM | #2 |
Gone Crazy
Join Date: Jan 2007
Location: Chesterfield, Va
Posts: 6,021
|
Re: 1990 EZ GO Caburetor rebuild kit
Welcome to BGW! You usually don't need a kit when cleaning or rebuilding these carbs.
Get the gallon can of "gunk" carb cleaner, comes with a little parts basket inside. Pull the carb, remove the bowl, float,low speed needle, jets and anything else and soak them and carb body for a couple hours. Soak the float and needle for around 20 mins and then wash everything with water. I wash/rinse with water first so when you blow it out you are not blowing carb cleaner into the air or all over other stuff. reassemble, set float at level. screw low speed jet in to bottom and back out 1 1/2 turns. Should be good to go. |
|
|
Similar Threads | ||||
Thread | Forum | |||
1990 EZGO Workhorse GXI-800 rebuild | Members Rides | |||
Fuel pump or caburetor | Gas Club Car | |||
only getting about 5# compression. 1990 G2 | Gas Yamaha | |||
B 1990 EZ-GO Cart | Gas EZGO | |||
My 1990 E-Z-GO | Members Rides |