|
|
|||||||
| Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
  |
|
|
Thread Tools | Display Modes |
08-03-2011, 11:50 AM
|
#1 |
|
Not Yet Wild
Join Date: Nov 2008
Posts: 10
|
Bolt size for driven clutch puller
I am replacing the spring on my G1 driven clutch. The cart is located at a camp and it's a good distance to any hardware stores. I would like to know the bolt size of the two bolts that screw into the driven clutch fixed sheave so I can make a puller to remove it. Thanks for any help or advice anyone can provide.
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
08-03-2011, 08:21 PM
|
#2 |
|
Gone Wild
Join Date: Jun 2009
Location: Heluvabump,VT
Posts: 623
|
Re: Bolt size for driven clutch puller
The bolt holes are metric, 6mm x 1.0 thread. Length will depend on the puller you are using. For the setup pictured below, I would use bolts at least 60mm long.
|
|
|
|
|
08-04-2011, 10:07 AM
|
#3 |
|
Not Yet Wild
Join Date: Nov 2008
Posts: 10
|
Re: Bolt size for driven clutch puller
Thank you very much GMB74.
 I really appreciate the reply and picture. You couldn't have made it any easier. Thanks again: Frank |
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Clutch puller bolt | Gas Club Car | |||
| Can someone tell me specs for clutch puller bolt? | Gas Club Car | |||
| Comet Clutch Puller Thread size?? | Gas Yamaha | |||
| What size thread for Primary Puller Bolt? | Gas Yamaha | |||
| 96 DS stock drive clutch bolt size (exterior bolt) | Gas Club Car | |||
Linear Mode
