|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
09-28-2013, 07:34 AM | #11 |
Gone Wild
Join Date: Feb 2008
Location: Brooklyn, Michigan "Home of M.I.S."
Posts: 3,667
|
Re: 1994 jacobsen/workhorse 810 want pull a hill
Well the governor controls the rpm and at a certain rpm cuts back the throttle, if you tighten the nut you will get more rpm before it cuts back.
You could also jack up the rear, pull the seat, hold it to the floor and watch the throttle to see if that's your problem. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
09-28-2013, 10:23 AM | #12 |
Gone Wild
Join Date: Jul 2012
Location: Stuart, Fla
Posts: 205
|
Re: 1994 jacobsen/workhorse 810 want pull a hill
Have you checked to make sure all the linkages are moving free? Also where is the air intake on this cart? I know for a while the intake hose was routed to the side of the cart. This was a big problem as there was dirt and dust getting into the motors and killing them. You should try a compression test on the engine. Also check your clutched to see if they are moving freely open and closed, maybe one is stuck or broke.
|
09-28-2013, 05:02 PM | #13 |
Not Yet Wild
Join Date: Sep 2013
Location: dobson nc
Posts: 9
|
Re: 1994 jacobsen/workhorse 810 want pull a hill
How lose or how tight should the drive belt be ? Does the clutch on motor suposed to slam when it moves? My belt is 42 in long outside diameter and very easy to take off and put back on
|
09-28-2013, 09:49 PM | #14 |
Not Yet Wild
Join Date: Sep 2013
Location: dobson nc
Posts: 9
|
Re: 1994 jacobsen/workhorse 810 want pull a hill
Air intake is under pass legs not coming out of side of cart and doing a compression check this week
|
09-28-2013, 10:42 PM | #15 |
Not Yet Wild
Join Date: Jul 2013
Posts: 25
|
Re: 1994 jacobsen/workhorse 810 want pull a hill
your belt should not be that loose. I would take seat off, drive cart and look at belt to see if it is slipping.: adj. gov and by a tach!!!
|
10-01-2013, 11:15 AM | #16 |
Not Yet Wild
Join Date: Sep 2013
Location: dobson nc
Posts: 9
|
Re: 1994 jacobsen/workhorse 810 want pull a hill
Did compression test one side is around 130 and the other is a little above 140 any more suggestion I'm going to pull drive clutch next and check it out
|
Tags |
1994, 810, jacobson |
|
|
Similar Threads | ||||
Thread | Forum | |||
Yamaha G8-A trouble running - have to pull choke to get up a hill | Gas Yamaha | |||
95 ezgo workhorse slow up hill | Gas EZGO | |||
cart slower down hill than up hill | Gas EZGO |