|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
09-30-2013, 05:26 AM | #11 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: ezgo controller testing
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
09-30-2013, 10:17 AM | #12 | |
Gone Wild
Join Date: Aug 2013
Posts: 187
|
Re: ezgo controller testing
Quote:
|
|
09-30-2013, 07:12 PM | #13 |
Gone Wild
Join Date: May 2013
Location: Mississippi
Posts: 301
|
Re: ezgo controller testing
|
10-01-2013, 06:21 AM | #14 | |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: ezgo controller testing
Quote:
What you said is technically correct, but my reply was not to kingcobra,the OP with the 1994 Medalist Series cart, it was to the thread hijacker, eejay001, who listed the terminals on a PDS controller. |
|
10-01-2013, 07:41 AM | #15 |
Gone Wild
Join Date: May 2013
Location: Mississippi
Posts: 301
|
Re: ezgo controller testing
|
10-01-2013, 07:46 AM | #16 |
Gone Mad
Join Date: Oct 2009
Location: Buford, GA
Posts: 8,988
|
Re: ezgo controller testing
Must be nice. Around here, I'm either wrong or ****ING WRONG!!
|
10-01-2013, 08:32 AM | #17 |
Gone Wild
Join Date: May 2013
Location: Mississippi
Posts: 301
|
Re: ezgo controller testing
|
06-28-2015, 11:04 AM | #18 | |
Not Yet Wild
Join Date: Jun 2015
Posts: 1
|
Re: ezgo controller testing
Quote:
Rick |
|
06-28-2015, 12:32 PM | #19 | |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: ezgo controller testing
Quote:
The voltage between B- and M- not decreasing towards Zero as pedal is pushed towards floor could be a bad throttle input to the controller, or a bad controller. The 26V is lower than expected. Should be pack voltage less about 5V. The pre-charge resistor for a 36V system is typically in the 200Ω to 250Ω range and either 5W or 10W. The resistor probably isn't bad. And will not prevent the voltage between B- and M- from varying when pedal is pushed. |
|
07-21-2015, 12:21 PM | #20 |
Gone Wild
Join Date: Dec 2010
Posts: 635
|
Re: ezgo controller testing
Good Info
|
|
|
Similar Threads | ||||
Thread | Forum | |||
testing a controller for 48v regen II | Electric Club Car | |||
Testing Controller,Fixing Problem | Electric EZGO | |||
testing a 48volt controller out of the cart?? | Electric Club Car | |||
testing a controller | Electric Club Car | |||
Controller testing | Electric Yamaha |