lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric EZGO
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV.



Post New Thread  Reply
 
Thread Tools Display Modes
Old 10-18-2021, 01:18 PM   #1
Sougentlmn0140
Not Yet Wild
E-Z-GO
 
Join Date: Feb 2018
Posts: 23
Default Keep frying Solenoid at Slow Speed

I have a 36V EZGO...New Batteries. The Volt Meter Drops from above 36+ to mid -20's when under a load....all batteries & cells tested...all good.....Hogh Performance Motor & Alltrax 500A Controller....any ideas?
Sougentlmn0140 is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Old 10-18-2021, 01:26 PM   #2
DaveTM
Gone Wild
 
DaveTM's Avatar
 
Join Date: Oct 2012
Location: Southwestern Pa.
Posts: 4,891
Default Re: Keep frying Solenoid at Slow Speed

https://www.buggiesgonewild.com/showthread.php?t=3915Do you have a series motor or a Sepex motor....how to tell:
DaveTM is offline   Reply With Quote
Old 10-19-2021, 04:42 PM   #3
bronsonj
Gone Wild
 
bronsonj's Avatar
E-Z-GO
 
Join Date: Jan 2013
Location: Saint Petersburg, FL
Posts: 1,808
Default Re: Keep frying Solenoid at Slow Speed

First assumption, you are replacing the solenoids with a heavy duty golf cart solenoid, right? A standard duty golf cart solenoid was barely adequate for the stock controller and an automotive duty solenoid is nowhere near what the cart needs.

When you say it drops to mid 20's under load is that just the load of moving the cart or is that pulling something or mashing the throttle trying to go up hill?

That much of a drop tells me you either have a heck of a load or have some issue in the high current circuit. Have you checked for heat buildup in any of the cables after doing a run with a heavy load?

Fully charge the batteries and disconnect them from the charger and let the cart sit for about a dozen hours. Then measure the voltage of each battery. That's your gold-standard at rest voltage measurement. Then measure the full pack voltage before attempting to accelerate to full speed on flat ground. Also measure the voltage while accelerating.

Or, if you have a newer Alltrax controller you can just do a data log and it captures all the pertinent information and more.
bronsonj is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric EZGO


Thread Tools
Display Modes


Similar Threads
Thread Forum
90 Yamaha G8 - Slow Speed (SR48500, SW202, 600A Solenoid) Electric Yamaha
2013 G29 sputters at slow speed runs like a champ at higher speed Gas Yamaha
What's frying my potentiometer micro switch? Electric Club Car
36v ds frying batteries Electric Club Car
Keep frying micro-switches Electric Club Car


All times are GMT -5. The time now is 12:23 AM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2021, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. 2006-2017 Buggiesgonewild.com. All rights reserved.