|
10-06-2013, 04:17 PM
|
#1 |
|
Not Yet Wild
Join Date: Jun 2013
Posts: 12
|
Starter Generator on Clone
Can anyone tell me how to wire up the starter/generator on a motor swap. I don't use the stock setup. I think I only need the generator part of this. I'm confused if I need to use the stock voltage regular with setup with the started gen. Or how does this recharge your battery.
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
10-07-2013, 03:03 PM
|
#2 |
|
Gone Wild
Join Date: Jul 2012
Location: S.E. WIS
Posts: 176
|
Re: Starter Generator on Clone
I believe you need the voltage regulator in order to get the correct volts (14v +) to charge the battery. I think it's just three wires on the VR - ground, to solenoid/battery, and from SG. I can check mine tonight and let you know.
|
|
|
|
|
10-07-2013, 08:28 PM
|
#3 |
|
Not Yet Wild
Join Date: Jun 2013
Posts: 12
|
Re: Starter Generator on Clone
Thanks man I would appreciate that. That is my last obstacle to complete motor wise.
|
|
|
|
|
10-08-2013, 11:42 AM
|
#4 |
|
Gone Wild
Join Date: Jul 2012
Location: S.E. WIS
Posts: 176
|
Re: Starter Generator on Clone
(3) wires from VR 1.) Black - ground 2.) yellow connects to the wire coming from the S/G. 3.) red wire which provides the higher voltage to charge the battery goes to the top post on the solenoid. Hope this helps more.
|
|
|
|
 |
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| G9 starter generator | Gas Yamaha | |||
| starter generator.... | Gas EZGO | |||
| Generator wiring on clone | Clone Engine Swaps | |||
| 88 ezgo gas starter/generator stuck in starter mode | Gas EZGO | |||
| Starter Generator Getting Hot | Gas Yamaha | |||
Linear Mode
