06-06-2010, 06:52 PM | #1 |
no clue
Join Date: Sep 2009
Location: spicewood, texas
Posts: 3,308
|
pulser ohms
well i am confused. have a 89 3pg that has no fire. it used to till a rebuild. same pulser coil,etc. but in testing we found two pulsers with 155-156 ohms. looking at jons advice in the tech section it should be 75. but does not say for which engine. after going thru two pages of search, i see where there a lot of 155 range pulser out there. one guy said his manual says 155 (1986) i can't find a pre 89 manual to confirm this, so does anyone either have one or an opinion? ? jim
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-06-2010, 09:27 PM | #2 |
Gone Wild
Join Date: Jan 2009
Location: Alabama
Posts: 2,120
|
Re: pulser ohms
This is opinion and I can't confirm this. If the 86 model had a 155 ohm, then chances are very good yours does too. You should be able to check some sellers sites and see if the part numbers for those years pulsers are the same. I would bet they are, that would confirm the 155 ohms.....
|
06-07-2010, 12:19 PM | #3 |
no clue
Join Date: Sep 2009
Location: spicewood, texas
Posts: 3,308
|
Re: pulser ohms
tony, just checked and all pulsars (sp. per ezgo) for the 2 cycles are the same. part 17452-g1. anyone have a new one they could check the ohms
on? in the first post i should have credited ruredy-sorry about that. jim oops! jon=ruredy? Last edited by madoc1; 06-07-2010 at 12:23 PM.. Reason: oops |
06-08-2010, 09:22 PM | #4 |
no clue
Join Date: Sep 2009
Location: spicewood, texas
Posts: 3,308
|
Re: pulser ohms
figured out the prob. it now runs great with 156 ohms at the pulsar.
don't know, it just seems as long as you have a pulse, the ohms don't count for much. just a cheap opinion. (you get what you pay for.) jim |
06-09-2010, 09:37 AM | #5 |
Gone Wild
Join Date: Jul 2009
Location: Chardon Ohio
Posts: 257
|
Re: pulser ohms
The pulser generates a/c voltage. I never use a ohm meter just hook up a volt meter set to a/c and you should have 1/2 volt a/c while spinning over the engine...
|
|
|
Similar Threads | ||||
Thread | Forum | |||
pulser coil | Golf Carts and Parts | |||
controller sees over 5000 ohms | Electric EZGO | |||
how many ohms for coil | Gas EZGO | |||
pulser coil | Gas EZGO | |||
G1 Pulser coil | Gas Yamaha |