|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
02-01-2018, 11:35 AM | #1 |
Gone Wild
Join Date: Sep 2010
Posts: 190
|
V-Glide clean and adjust questions
2000 DS Club Car:
Going through all my wires, cleaning and finding living close to the sea doesn't help. Once I got into the V-Glide I noticed the "paper film" that apparently used to cover the contact "buttons" has come off. In fact the wire that runs to the go-pedal wiper was worn through. So, can this V-Glide be just cleaned and adjusted or is it time to go shopping? (I can tape up the wire, but can those buttons work properly w/o that paper material? Or did they come from elsewhere?) Thanks |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
02-01-2018, 11:49 AM | #2 |
Gone Wild
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 9,329
|
Re: V-Glide clean and adjust questions
Can You post a picture of what you are referring to?
|
02-01-2018, 04:03 PM | #3 |
Gone Wild
Join Date: Sep 2010
Posts: 190
|
Re: V-Glide clean and adjust questions
|
02-02-2018, 07:02 PM | #4 |
Gone Wild
Join Date: Sep 2010
Posts: 190
|
Re: V-Glide clean and adjust questions
I'm just going to replace it. If I'm going through all the work of pulling it apart, may as well just replace. It's got three wires. Is this going to be a difficult part to replace?
Thanks |
02-02-2018, 10:31 PM | #5 |
QualityCarts
Join Date: Dec 2014
Location: South florida
Posts: 305
|
Re: V-Glide clean and adjust questions
It's really easy to clean/restore the vglide, I just did mine. Half hour.
|
02-03-2018, 04:16 AM | #6 |
Gone Wild
Join Date: Sep 2010
Posts: 190
|
Re: V-Glide clean and adjust questions
|
02-03-2018, 04:19 AM | #7 |
Gone Insane
Join Date: Oct 2016
Location: Richmond, VA
Posts: 14,214
|
Re: V-Glide clean and adjust questions
Do what Sergio says to do.
|
02-03-2018, 10:29 AM | #8 |
Gone Wild
Join Date: Sep 2010
Posts: 190
|
Re: V-Glide clean and adjust questions
|
02-04-2018, 05:37 PM | #9 |
QualityCarts
Join Date: Dec 2014
Location: South florida
Posts: 305
|
Re: V-Glide clean and adjust questions
Pull it apart, take a dremel tool with a sandpaper attachment, use it to clean all the brass conctacts, and also the wiper arm contact. Test continuity after cleaning using digital volt meter. You should get either 0k-5k. Or 5k-0k, open to close, depending which glide you have.
|
02-04-2018, 05:39 PM | #10 |
QualityCarts
Join Date: Dec 2014
Location: South florida
Posts: 305
|
Re: V-Glide clean and adjust questions
The wires can all be replaced easily. You'll see where the attatch to when you open the glides case
|
|
|
Similar Threads | ||||
Thread | Forum | |||
V glide questions. | Electric Club Car | |||
How Clean is Clean...Before Priming | Body and Paint | |||
V glide and speed questions | Electric Club Car | |||
how to adjust the wiper arm on a 2003 v-glide | Electric Club Car | |||
V-Glide doesn't glide - 1992 36v | Electric Club Car |