|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
04-09-2016, 02:55 AM | #1 |
Gone Wild
Join Date: Oct 2010
Location: Fort Worth, TX
Posts: 215
|
1998 g16 primary clutch belt tension question
See attached picture. I'm thinking my primary clutch belt is not coming up high enough on the clutch. I'm getting some slipping of the belt on really steep hills. I have more than an inch of play on the belt. Tightened it with a strap pulling it tight with the belt on. Should I remove belt move engine forward then tighten and then put the belt on?
I'm thinking the belt should go higher on the primary, so belt is too loose. What do you think? Cart is lifted with 22"tires. New Vegas carts motor clutch and belt, secondary is all new except for outer sheave, set at b2,which I plan on changing to b3 while I'm in there. Would b2 setting cause this? Thanks for the help! |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Drive belt tension/belt burning | Clone Engine Swaps | |||
1998 Club Car clutch and belt question | Clone Engine Swaps | |||
Belt Tension | Gas Yamaha | |||
belt tension question | Clone Engine Swaps | |||
Spring on Primary Clutch wearing groove in Belt | Gas Yamaha |