|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
10-30-2013, 12:27 AM | #1 |
Not Yet Wild
Join Date: Sep 2012
Location: california
Posts: 31
|
g1 and g2 axle and transmission question
Hi everyone im new here im built a lifted g1 with a 420cc clone engine for fun offroading. But it is only fun till I need to reverse and cant no reverse in g1 I got a hold of a g2 cart for parts can i swap the g2 transmission into the g1 axle. I know the g2 is offset so I cant do a direct axle swap and the mounting will need to be changed but will the g1 slide right in and bolt of to the g2 transmission without any issues. Any help is greatly appreciated thanks
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
10-30-2013, 01:42 PM | #2 |
Admin/Moderator
Join Date: Dec 2006
Location: Ohio
Posts: 18,010
|
Re: g1 and g2 axle and transmission question
Welcome to BGW!
Just swap out the entire rear end. |
Ron
PLEASE VISIT Our Sponsors * BGW GEAR The Store The G2 Project * Swing Arm Drop & Repair * Geep1 Project |
|
10-30-2013, 03:56 PM | #3 |
Not Yet Wild
Join Date: Sep 2012
Location: california
Posts: 31
|
Re: g1 and g2 axle and transmission question
Thanks for the welcome and the reply but I was hoping to not have to move the motor and just change the transmission since the g2 transmission is shifted to one side. Would the trannys be interchangeable
|
10-31-2013, 10:31 AM | #4 |
Admin/Moderator
Join Date: Dec 2006
Location: Ohio
Posts: 18,010
|
Re: g1 and g2 axle and transmission question
I'm not sure, but I don't think that will work.
|
Ron
PLEASE VISIT Our Sponsors * BGW GEAR The Store The G2 Project * Swing Arm Drop & Repair * Geep1 Project |
|
10-31-2013, 04:10 PM | #5 |
Searching for The Way
Join Date: Oct 2009
Location: Medina, Ohio (NEOHIO)
Posts: 11,421
|
Re: g1 and g2 axle and transmission question
Yeah the G2 secondary clutch location is different than the G1. You'll have to make some modifications to get it right, but shouldn't be too bad. Grinder, welder, level, bandaids and beer....should be enough to get you going.
|
10-31-2013, 06:15 PM | #6 |
Vegas modded 420
Join Date: Jun 2009
Location: West MI
Posts: 15,433
|
Re: g1 and g2 axle and transmission question
Yeah the G2 was built near the end of the G1's production run, its similar but different. There is another thread about it here, a few in fact. Some may be in the clones section.
|
Tags |
axle, transmission |
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Transmission Question | Gas Yamaha | |||
G1 rear/transmission question | Gas Yamaha | |||
Axle question | Bike & ATV Engine Swaps | |||
General transmission question | Gas EZGO | |||
rear axle question | Electric EZGO |