Need torque specs for king pin, steering linkage, and hub fast !!

[dbmachine]

Im in the process of installing the jakes 3" lift on my g29 and have everything reassembled but need the proper factory torque specs for each componant. Jakes instructions give no mention of torque specs and the youtube video that snug it back together with a battery impact like i used but wanna make sure i dont go too tight.

Need the front wheel hub 19mm nut specs

Need the 14mm king pin strut bolt specs

Need the 17mm nut for the steering linkage spec


Finally when i get to the rear need the top shock absorber bolt specs.

Thanks for the help guys hope to finish everything tomorrow. Very easy so far to install. Also wandering where there is absolutely no cotter pins on any bolt on this cart. All the nuts were quality marked with a black marker pin but no cotter pins anywhere.

Originally Posted by dbmachine

Need the front wheel hub 19mm nut specs tighten nut til hub is hard to turn , back off nut til hub turns freely, install cotter pin

Need the 14mm king pin strut bolt specs 35~45 ft/lbs

Need the 17mm nut for the steering linkage spec 18~24 ft/lbs

Finally when i get to the rear need the top shock absorber bolt specs. on upper shock mount tighten nut until rubber bushing expands to the size of the cup washer
lower nut to 50~60 ft/lbs

taken from service manual

[dbmachine]

Thank you crash test.. Headed to the shop to torque em down.