lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Gas EZGO
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV.



Post New Thread  Reply
 
Thread Tools Display Modes
Old 06-13-2015, 12:34 PM   #1
Trooper328
Not Yet Wild
 
Join Date: Jun 2015
Posts: 4
Default Electrical Issues

Sorry Guy, I know there's probly a thread on here explaining this, but its hard to look through them all.....What I've got is a 1994 Medalist that the wiring caught fire....I got a good deal on it and got most of it rewired, but have a couple of wires I'm not sure of....is there a wiring diagram that is more descriptive than the dealers manual.....its not very user friendly....thanks for any help
Trooper328 is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Old 06-14-2015, 08:12 PM   #2
Trooper328
Not Yet Wild
 
Join Date: Jun 2015
Posts: 4
Default Re: Electrical Issues

Ok guys, here's what I haven't figured out.....maybe someone can look at theirs and let me know.....

1. Where does the red key switch wire go to....I'm thinking the micro switch above the reverse alarm.?????

2. Where does the black wire with the in-line fuse go from the solenoid to where????
any and all help will be greatly appreciated.....thanks again
Trooper328 is offline   Reply With Quote
Old 06-14-2015, 08:45 PM   #3
jeffrun
Gone Wild
 
Join Date: Apr 2011
Location: Washington State
Posts: 385
Default Re: Electrical Issues

yep,red wire from ign sw goes to the micro sw with 2 tabs on top and connects there, the black wire with fuse connects to the same point,goes on the other tab with red wire,thats your hot feed to ign sw and buzzer.
jeffrun is offline   Reply With Quote
Old 06-14-2015, 08:52 PM   #4
Trooper328
Not Yet Wild
 
Join Date: Jun 2015
Posts: 4
Default Re: Electrical Issues

Thanks a lot......with all the wires being melted and the previous owner having a few add ons, it was kinda hard to trace all the wires back to their origin.....you were a big help jeffrun....now i'll finish it up tomorrow and see if I can get it running.....
Trooper328 is offline   Reply With Quote
Old 06-14-2015, 09:00 PM   #5
jeffrun
Gone Wild
 
Join Date: Apr 2011
Location: Washington State
Posts: 385
Default Re: Electrical Issues

if you have things lke headlights,stereo,etc they should be fuse seperate from the cart ign.fuse. good luck.
jeffrun is offline   Reply With Quote
Old 07-31-2015, 08:20 PM   #6
Trooper328
Not Yet Wild
 
Join Date: Jun 2015
Posts: 4
Default Re: Electrical Issues

Ok Jeffrun, maybe you can help me out with the next issue I've run into....or anyone else is sure welcome for their input......I've got it firing, but it will not run....I've checked the spark and its good.....the compression is very low.....40 in passenger side and 25 in driver side cylinder.....could the valves be the most likely culprit for this......and if so does anyone have a link to where I can get the specs for the valve settings....thanks again for any and all help
Trooper328 is offline   Reply With Quote
Old 07-31-2015, 08:37 PM   #7
jeffrun
Gone Wild
 
Join Date: Apr 2011
Location: Washington State
Posts: 385
Default Re: Electrical Issues

Yes, set the valve clearances to try and raise compression, there are stickeys above for the procedure. You should have at least 120psi or more to have a running engine.
jeffrun is offline   Reply With Quote
Old 08-01-2015, 01:11 AM   #8
sccowboy
It ain't gonna be easy.
 
sccowboy's Avatar
E-Z-GO
 
Join Date: Apr 2008
Location: St. George, SC
Posts: 1,471
Default Re: Electrical Issues

Here is the link: http://www.buggiesgonewild.com/ezgo-...djustment.html

Once you get the valves set, recheck the compression and go from there. Those initial readings will not support ignition. Try pouring a little oil into the cylinders and recheck compression. If it comes up, then the rings are shot. If not then the valves are not holding pressure.
sccowboy is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Gas EZGO


Thread Tools
Display Modes


Similar Threads
Thread Forum
94 G8 Electrical issues Electric Yamaha
electrical issues Electric Club Car
82 ezgo electrical issues Gas EZGO
36v ez-go electrical issues Electric EZGO
95 G14 Electrical Issues Gas Yamaha


All times are GMT -5. The time now is 07:50 PM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2022, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.