driven clutch

[casey46]

ok since no reply last time and forty hits, i am looking for a little advice this time,i tore my driven clutch apart on a 2005 ezgo, i notice after research the clutch ramps are gone, and the helix had some wear, statring metal to metal and the clutch washer i do not see one , can i clean all this up file it smoth and replace the ramps or should i bite bullet and buy assembally..thanks

[tonyton]

At near $300.00 for a clutch assembly, I would try to repair it. I cant see the extent of the damage, so I'm guessing it's still repairable. The internal parts are relatively cheap, you have the opportunity to change it to a 28 degree hi torque clutch by changing the internal parts. I'll see if I cant find those part numbers and give you and idea of what you're looking at, $$ wise.
I'll be back....

[casey46]

Originally Posted by tonyton

At near $300.00 for a clutch assembly, I would try to repair it. I cant see the extent of the damage, so I'm guessing it's still repairable. The internal parts are relatively cheap, you have the opportunity to change it to a 28 degree hi torque clutch by changing the internal parts. I'll see if I cant find those part numbers and give you and idea of what you're looking at, $$ wise.
I'll be back....

thank you, the helix is probabally the worse tore up besides the cams are gone,this washer i did not see one is the washer for two cycle thanks and thanks for reply

[tonyton]

I can't tell if these will be legible until it posts. These are EZ GO clutch parts. They don't specify 28 or 36 deg, but will give you an idea of cost.

[casey46]

Originally Posted by tonyton

I can't tell if these will be legible until it posts. These are EZ GO clutch parts. They don't specify 28 or 36 deg, but will give you an idea of cost.

ok thanks how do i make a 36 degree to a 28 degree,thanks...

[tonyton]

Different ramp buttons and the cam, I beleive. We need to find a post from the past, it has the part numbers and info needed for that. It's in here somewhere....
It's just like yours, but different numbers.
Start with related posts at the bottom of the page...it could (should) be in the tech section.

[tonyton]

I found this in a catalog (I love my manuals and parts books)
From left to right #2 is the cam p/n 72329 G01 The ramp buttons #5 is p/n 72324 G01. That is all the 28 degree stuff listed in the EZ GO catalog. You shouldn't need these, but just in case.....
The clip, retaining is 27270G01
The spring (bottom rt.) is 26304G01
BTW, cart parts plus machines these clutches for performance and may be able to hook you up....site sponsor. Hope that helps. Tony
These are OEM part numbers

[casey46]

Originally Posted by tonyton

I found this in a catalog (I love my manuals and parts books)
From left to right #2 is the cam p/n 72329 G01 The ramp buttons #5 is p/n 72324 G01. That is all the 28 degree stuff listed in the EZ GO catalog. You shouldn't need these, but just in case.....
The clip, retaining is 27270G01
The spring (bottom rt.) is 26304G01
BTW, cart parts plus machines these clutches for performance and may be able to hook you up....site sponsor. Hope that helps. Tony
These are OEM part numbers

i dont see cart parts plus link, thanks

[tonyton]

http://cartpartsplus.com/
You' have to call for machining prices. Hope that works tony

[GXTsandman]

If it can be fixed, I'd fix it but you don't want to spend the time and money than end up breaking down and buying a new one anyway.