97 txt will not move

[HGC2010]

97 txt will not move. Reverse buzzer works, solenoid clicks, and battery pack is at 36 volts.

Cart does nothing either direction.

[scottn73]

Originally Posted by HGC2010

97 txt will not move. Reverse buzzer works, solenoid clicks, and battery pack is at 36 volts.

Cart does nothing either direction.

I had a 97 that did the same thing. But first check all connections everywhere. If you have done that then check the throttle switch that is located under the floor mat on the drivers side. That was went out on mine it took me forever to figure that out. When you get the cover off it make sure cart is off and take your fingure and push on the little wheel and listen to see if the switch clicks. or just push gas pedal.

[HGC2010]

That checks ok. Solenoid clicks.

[scottn73]

Originally Posted by HGC2010

That checks ok. Solenoid clicks.

Next thing to do is to run a voltage check on the solenoid and at the controler then check voltage at the f/w. From experience even if the micro switches click they can still be bad.

[scottyb]

Does the cart have a Toggle switch for Run/Tow on the environmental controller cover?

[HGC2010]

Scotty it does not have a tow switch.

[scottyb]

Okay, You have a series cart. The solenoid clicks but the cart does not move.
Get one rear wheel off the floor for safety. Double check the obvious, key on, cart in 'gear', depress peddle, hear solenoid click? Check battery pack 36v+ going in and OUT of the solenoid big terminals.
If solenoid switch if functioning properly. Check controller out put as follows:
Check the power output from the controller by connecting the negative probe to the controller's M- terminal and positive to the B+ terminal. Press the accelerator and watch to see if the voltage increases. It should increase from a reading of 0 to the full voltage of the battery. If the motor is not turning, the problem may be in the directional switch or motor. The controller is bad and must be replaced if there is no voltage.

[HGC2010]

Voltage does not move when checking the controller.

[scottyb]

If you have checked that the controller has power at B+ and at the red wire pin #4, and have conducted the test above correctly then the controller is bad.

[HGC2010]

Changed controller and still nothing. Cart seemed to move a little then nothing.