txt rear driven clutch

[aronw2004]

The retraining bolt for my txt rear driven clutch assembly has come loose and fallen off.
anyone know what size bolt this is??
Many thanks

[trig123]

Originally Posted by aronw2004

The retraining bolt for my txt rear driven clutch assembly has come loose and fallen off.
anyone know what size bolt this is??
Many thanks

Its a 5/16th USS thread by 4 inches long. Grade 5 or 8 will do. Did it break off in shaft ? you also need the bushing that goes in clutch if you don't have it.

[aronw2004]

Originally Posted by trig123

Its a 5/16th USS thread by 4 inches long. Grade 5 or 8 will do. Did it break off in shaft ? you also need the bushing that goes in clutch if you don't have it.

Iv just had a look now and it has infact broken off.

Any tips on removing the broken bolt? Heat and a self tapper i was thinking.

Whats the bush? And where does it go? Tia 👍🏻

[trig123]

Originally Posted by aronw2004

Iv just had a look now and it has infact broken off.

Any tips on removing the broken bolt? Heat and a self tapper i was thinking.

Whats the bush? And where does it go? Tia 👍🏻

It shouldn't be tight . Don't use heat. If it were me I would use a 1/4th inch or smaller left hand drill bit but again you need to drill it straight. Center punch it before you start. Screw Extractor also will work. You ever done this before ?
Google this number

25756G1 for your bushing. I buy them at country cat but I will leave that to you. You also need a 5/16th lock washer . Here is what the bushing looks like.

[aronw2004]

how far into the splined shaft does the thread go? the new bolt hasnt arrived yet and without it i cant be sure if iv removed all the bolt.
iv cleaned the thread with a tap n die set so im just waiting on the new bolt to arrive but i might not have had it out. thanks

[kgsc]

Should be about 1 to 1 1/4 of thread. https://www.countrycat.com/arctic-ca...G01%7c%7eF-1/y

[trig123]

Exactly 1 and 1/4th inches to the end is what one I have here in the shop measures.