|
08-16-2017, 02:40 PM
|
#1 |
|
Not Yet Wild
Join Date: Jul 2017
Posts: 2
|
Ignition issues
I have a 2008 EZGO MPT with a Robin EH352 engine, stripped it down to the frame for blasting and repainting. Put the engine back in and now I have no spark to the plugs, I have voltage to the 4 prong plug that goes to the Spark Plug wire bank but nothing to the plugs. Don't know if I have a wire crossed or not. It ran good before the tear down. Any ideas would be appreciated
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
08-16-2017, 03:37 PM
|
#2 |
|
Gone Wild
Join Date: Mar 2013
Location: Blackshear, GA
Posts: 226
|
Re: Ignition issues
Hey dave, there should be a wiring diagram in the ez go gas tech sub-forum right above this board. i know because I have been chasing a electrical bug for a while and finally got it sorted out.
Hope that helps some! |
|
|
|
 |
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| EZGO deluxe light install and 3 way ignition issues | Electric EZGO | |||
| Pre MCI ignition and MCI ignition parts compatibility | Gas EZGO | |||
| 1966 D Gas ignition issues | Gas Harley Davidson | |||
| 92 club car ignition coil issues | Gas Club Car | |||
| Yamaha G9-Ignition Coil & Ignition Switch-Help | Gas Yamaha | |||
Linear Mode
