05-17-2018, 09:32 AM | #1 |
Not Yet Wild
Join Date: Apr 2018
Posts: 21
|
oil mix question ?
I have my engine apart and will install a kit ,crank and piston ,ect . When I took it apart I was kind of surprised to see the oil pump still hooked up and working .I pulled the hose off and plugged it before removal .Question is ,can I assume that I can just hook up the hose and call it good when I install the engine again?
would I need to make sure its bled the air out of it .? I could just mix and that sounds like the best deal, I would hate to ruin the new engine with a screw up with the oil pump. If I decide to mix ,what ratio for initial start and when do I change the ratio , and to what? Thanks Sorry for the edit ,its a 91 two cycle ,EZ-GO. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
05-17-2018, 09:37 AM | #2 |
Test before replacing
Join Date: Aug 2013
Location: Ohio side of the Pennsylvania border.
Posts: 3,495
|
Re: oil mix question ?
Your first tank full will be 40:1, after that mix 128:1.
I would not use the oiler at all. Get rid of it. Make sure you install the piston with the side ports facing the intake, and make sure that you install the rings bevel side up. The ends of the rings will wrap around little alignment pins in the ring grooves. You should also check ring end gap before installing. |
05-17-2018, 10:00 AM | #3 |
Not Yet Wild
Join Date: Apr 2018
Posts: 21
|
Re: oil mix question ?
Thanks for the reply ,what gap should they have? do I have to plug anything when I take the oil pump off?
|
05-17-2018, 11:21 AM | #4 |
Test before replacing
Join Date: Aug 2013
Location: Ohio side of the Pennsylvania border.
Posts: 3,495
|
Re: oil mix question ?
.008" -.016" https://www.vintagegolfcartparts.com...p-engine-specs
Plug the intake manifold where the oiler banjo attaches. 6mm. |
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Upgrade question.. I am upgrading my cart and have a question on a part. | Electric Club Car | |||
1990 Club car With flat head Rev limiter question and govenor question | Gas Club Car |