|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
07-10-2014, 08:52 AM | #11 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Charger won't cut off
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-10-2014, 08:38 PM | #12 |
Gone Wild
Join Date: Oct 2013
Posts: 407
|
Re: Charger won't cut off
Well, I cleaned everything again and just can't believe that could be the problem at this point, but it still won't cut off. I put the batteries on a 12 volt charger and it charged each pair a few minutes and they all cut off, so I don't think there is anything wrong with the batteries. Put it back on the cart charger, but it never would cut off.
It takes the pack to 46.2 volts and that's all the charge it will accept, but the charger keeps humming along. I was hoping to avoid going into the charger to try to run JohnnieB's troubleshooting test, but I guess I'll need to try it. I don't feel competent to take the charger apart. When I go into things like that, they somehow never seem to work again. I'm gonna go look at another cart tomorrow to leave on my farm which is 90 miles away from my home. It has a charger with it, so I may wait and try it on the cart before I tear the charger apart. I miss my old resistor cart. I could figure out what was wrong when it had problems. Plus, it would run really fast down a hill. |
07-11-2014, 08:19 AM | #13 |
Gone Wild
Join Date: Oct 2013
Posts: 407
|
Re: Charger won't cut off
Maybe the cleaning worked after all. I ran it several miles late yesterday and took it down to 75% charge, then put it on the charger. When I went to bed at 10, it was reading 45.9 volts, so I left it on all night. This morning it had cut off and pack voltage was 38.8.
Thanks for all the help! |
07-11-2014, 08:34 AM | #14 |
Gone Mad
Join Date: Oct 2009
Location: Buford, GA
Posts: 8,988
|
Re: Charger won't cut off
Is it possible that the charger has to remain at 44 - 46 volts for a certain amount of time before shutting off?
|
07-11-2014, 09:20 AM | #15 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Charger won't cut off
I believe the control boards in the legacy ferroresonant transformer type chargers just used a simple voltage comparator, but they might have tossed in a time delay of some kind to keep line voltage spikes from shutting it off prematurely. Probably no more than a few seconds delay though.
|
07-11-2014, 11:44 AM | #16 | |
Gone Wild
Join Date: Oct 2013
Posts: 407
|
Re: Charger won't cut off
Quote:
If not, then I guess there is some kind of problem with the charger or the batteries. The old Lestronic would charge this same battery pack and then cut off within a few hours, even when the cart was down to 50%. It didn't this time, which is making me start to wonder if there is a problem with one or more of the batteries. With the previous set of batteries, the Lestronic would not cut off after the batteries were about 4 years old. I'd just unplug it after the amp meter was near zero, and occasionally I would charge the pack completely using a 12 volt charger. I got 3 more years out of the pack using it that way. When I put new batteries in the cart, the Lestronic went back to working normally. These are Trojan 105s and only about 10 months of use. |
|
07-11-2014, 12:11 PM | #17 |
Gone Wild
Join Date: Jun 2014
Location: Brandon MS
Posts: 309
|
Re: Charger won't cut off
I was going to say try hitting it with a hammer, but try what johnnyB said first.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Don't have a 48v charger. Is a 36v and a 12v charger a practical temporary solution? | Electric EZGO | |||
Powerwise charger w/ Club Car round three prong charger plug HOT!! | Electric EZGO | |||
new batts and charger wont charge, charger works on other carts | Electric Club Car | |||
How to hook up 12volt charger with 36 volt charger to charge 48 volts | Electric EZGO | |||
converting an old style dial charger to a smart charger for Marathon | Electric EZGO |