07-02-2018, 09:02 PM | #1 |
Not Yet Wild
Join Date: Mar 2013
Location: wytheville va
Posts: 55
|
2pg no power
I am working on 87 ezgo 2pg. Engine was rebuilt a year ago has new clutches. Has a dayco drive belt just bought. The cart has 120 psi fuel is premixed. The cart has no power it barely runs up a hill. Carburetor has been cleaned new air filter and plug. Fuel pump has a steady stream. Uncooked muffler made no difference also tried open the breather. Clutches are working correctly. Has a decent blue spark. I did find out the voltage regulator is going bad. Checked volts it was 14.4 while cart was at top speed. After 30 minutes or so voltage started spiking to 17.5 volts. Any suggestion on why this cart won't run right or pull a hill. I tried searching but couldn't find any more things to try.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-02-2018, 11:39 PM | #2 |
Test before replacing
Join Date: Aug 2013
Location: Ohio side of the Pennsylvania border.
Posts: 3,495
|
Re: 2pg no power
Take the belt off and push it. See if the brakes are dragging.
|
07-02-2018, 11:57 PM | #3 |
Not Yet Wild
Join Date: Mar 2013
Location: wytheville va
Posts: 55
|
Re: 2pg no power
Seems to roll good with the belt off
|
07-03-2018, 01:51 AM | #4 |
Test before replacing
Join Date: Aug 2013
Location: Ohio side of the Pennsylvania border.
Posts: 3,495
|
Re: 2pg no power
While the belt is off, squeeze the plates together on the secondary clutch. If you can move them by hand at an angle, it is worn out. Nevermind. I see it is new.
|
07-03-2018, 10:03 AM | #5 |
Not Yet Wild
Join Date: May 2018
Posts: 64
|
Re: 2pg no power
Did you do the seals when you rebuilt the engine? If so did you loctie them in and stake in 3 places? Is your timing way off? Have you ever changed the gear oil in the rear end? Is the engine sitting correctly in the cart so you get the right gear ratio on the CVT setup? Just a bunch of total guesses.
|
07-03-2018, 11:05 AM | #6 |
Not Yet Wild
Join Date: Mar 2013
Location: wytheville va
Posts: 55
|
Re: 2pg no power
Seals are new. Checked for leaks by spraying wd40 around everything. It never changed the rpms. As far as I can the engine is bolted in there correctly. Not sure on the timing I didn't build this one.
|
07-03-2018, 05:39 PM | #7 |
Not Yet Wild
Join Date: Mar 2013
Location: wytheville va
Posts: 55
|
Re: 2pg no power
Just checked for leaks with smoke. Only place smoke was leaking was at the base of the fuel pump. I put the hose from carb in a bottle at first had a good stream then nothing but a little dribble once in awhile
|
07-03-2018, 05:43 PM | #8 |
Not Yet Wild
Join Date: Mar 2013
Location: wytheville va
Posts: 55
|
Re: 2pg no power
Just rechecked clutches drive clutches had no play and spring has good resistance. The secondary clutch has about 1/8 of movement now. It's only a year old.
|
07-03-2018, 07:00 PM | #9 |
Test before replacing
Join Date: Aug 2013
Location: Ohio side of the Pennsylvania border.
Posts: 3,495
|
Re: 2pg no power
Since you are running out of options, check this out. http://www.buggiesgonewild.com/gas-e...fuel-pump.html
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Cart looses power, let off the go pedal and power again | Electric Club Car | |||
Full power in reverse, part power in forward | Electric EZGO | |||
Ezgo dies under power then regains power | Electric EZGO | |||
2005 Precedent starts of powered, then loses power, reverse always power | Electric Club Car | |||
Power Wise Charger worked after board replaced now back to no power | Electric EZGO |