lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Gas EZGO
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV.

Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 08-24-2010, 02:18 PM   #1
Hammer Down !!!!
BrewCityMusic's Avatar
Join Date: Jun 2010
Location: Lake Geneva, WI
Posts: 2,681
Default 10.4v to coil wires until i hook up coil, then zero

The title says it all, pretty much - if I put a DMM on the wires to the coil with no coil hooked up, I get 10.4v while turning it over, then I hook up the coil and get zero voltage when turning it over ...

It's an 88 Marathon 2 stroke, BTW - also, I noticed that the voltage slowly climbs to 10.4 as I'm turning it over, for the first few turns it's at 3-ish, then 5ish, etc until she gets rolling good, then it's at 10.4 (also, the engine takes a second to start turning over when you step on the gas, then slowly builds to full cranking RPM's) - solenoid? Regulator? PLEASE HELP !!!!!

This is the third time I replaced the coil (I have no way to test them, so for all I know all 3 are still good) - would the ignitor be the problem, perhaps (I could always go HEI) ???
BrewCityMusic is offline   Reply With Quote
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Gas EZGO

Thread Tools
Display Modes

Similar Threads
Thread Forum
coil on G1 Gas Yamaha
Coil wires Gas EZGO
coil?? Gas EZGO
ez-go coil Golf Carts and Parts
need a coil for a 81 G-1 Golf Carts and Parts

All times are GMT -5. The time now is 07:45 PM.

Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2022, vBulletin Solutions, Inc.
This Website and forum is the property of No material may be taken or duplicated in part or full without prior written consent of the owners of 2006-2017 All rights reserved.