|
Design Center Shop tools, fabrication and Paint and Body |
|
Thread Tools | Display Modes |
09-14-2010, 08:26 PM | #1 |
Gone Wild
Join Date: May 2010
Location: OHIO
Posts: 1,517
|
measurement help
hey guys i lost my digital caliper and need some help with some measurements
ok so if i have a 1-1/4" OD pipe with a .120" Wall would the inside hole be 1" and the OD be 1 1/4" ???? |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
09-14-2010, 08:51 PM | #2 |
steeplejack x
Join Date: Jan 2007
Location: Republic of Texas
Posts: 3,382
|
Re: measurement help
It depends on if it is tube or pipe.
If it is 1-1/4" Sched 40 pipe then the OD is about 1-5/8" and the ID about 1-3/8". If it is tube then the OD is 1.25" and the ID is about 1.01". This can vary based on the the grade/specification of the tube. Seamless, DOM, HREW, CREW, etc. all have different specs. Yeah, it can get confusing for sure. |
09-14-2010, 09:03 PM | #3 |
Gone Wild
Join Date: May 2010
Location: OHIO
Posts: 1,517
|
Re: measurement help
Item number: 200431281159 on ebay
|
09-14-2010, 09:20 PM | #4 |
steeplejack x
Join Date: Jan 2007
Location: Republic of Texas
Posts: 3,382
|
Re: measurement help
DOM (Drawn Over Mandrel)
1.25" OD x 1.01" ID @ 1.448 lb/ft |
09-14-2010, 09:24 PM | #5 |
Gone Wild
Join Date: May 2010
Location: OHIO
Posts: 1,517
|
Re: measurement help
thank u
|
|
|
Similar Threads | ||||
Thread | Forum | |||
HEI conversion "pre work" / need pg3 measurement | Gas EZGO | |||
Only because my cart is at the CG I need a pic and measurement...please | Gas EZGO | |||
need a measurement | Electric EZGO | |||
Need A Measurement | Electric EZGO | |||
CC DS Measurement - Bumper to rear tire? | Gas Club Car |